Recent content by Joe G.

I am getting a signal of 90% and my quaility signal flucuates between 45%- 73% . I have checked all my connections- everything is good. I am usinga DISCqE switch before the motor between the lnb and motor. Do I need to install a multi-switch???

Well, I was finally able to secure a signal using the last set of instructions where I took the motor off, set dish on pole, followed all directions. Now I want to install motor , switches etc... What I find confusing is that dishpointer.com , for my lat. =33.74 , Long -112.33 gives me these...

I have been out of state and I still haven't been able to get my system going. I tried the last settings from Oct. 29,2015- I replaced LNB with a universal LNBF , replaced reciever and by passed motor. I have hooked up just one of the linear connections and still no signal. I have used a...

So do I not use the circular connections on my quad LNB?Anyway you could send me a drawing to wire from receiver-motor-switch-lnb???

I am sorry that I went this way. I am not familiar with your protocal-as for the circular polarity, I am very new to to the FTA system and am just trying to make sure that I have what I need when ever I get this thing going without knowing that circular polarity is not common to FTA. If I knew...

can anyone tell me how to connect the quad lnb to dish motor. Which port on the LNB (port 1-C,-port2-L,port3-c,port4-L ) goes to the dish motor lnb port

Thanks for your feed-back Right now , I have my dish pointed to 97. degrees west towards Galaxy 19( elevation 47.5 degrees N ) just to try ,align and get this thing going. Once I can get something going , I want to get on to galaxy 14,or whatever is on that elevation 0f 48.5 degrees N. I want...

I want to make sure that I don;t screw up anything- I am sending a diagram of how I have it hooked up presently- please show me what to do- I will be grateful for any help in this setup- Thank you- Joe G.

Getting back to my Invacom Quad LNB- coming out of the LNB, which port is going to the switch- my switch is as follows on the input side- 1ma-2ma- 3ma 4ma- do I hook them up exactly like my lnb C -1ma, L-2ma,C-m3,L-4ma, then mu out put is as follows: rec-1 , rec-2, rec-3, rec-4, ,rec-5, rec-6...

getting back to my Invacom quad LNB to a Spaun DMS 5802 NF and the x2 premium receivers. On my last post I think I understand that you hook up 1 receiver to dish motor first ,but which one?? I understand that part- From the motor ,where does it goes connected on the multi-switch, the input...

I don;t think I understand!!! I have two receivers, which one do I connect to??? If I think I understand- I go from the receiver, straight to the dish motor (REC ) side , then from the LNB side on the motor to the Spaun DMS 5802 NF multi-switch, then back to the LNB ??? The LNB has 4 ports...

I want to know how to connect a Invacom Quad Polar LNB w/ a 40mm horn to the dish motor and to a Spaun DMS 5802 NF multi-switch. Do I still need to get a 2 x 1 DISEqc switch if I have that multi-switch??. ON my quad LNB - it is as follows, from left to right- C , L , C , L - when I tried to test...