Recent content by johnhicks

they are all in the 20's on a good day. 129 is the worst, of coarse!

It is all RG6 with a mixture of copper and copper clad but has 8 or so F connectors with 2 barrel connectors

I need some input on a good amplifier for an application that has long drops and numerious connectors. This application has a 1K.2 which is fed by a 300, TREES, TREES, and picks up 110, 119 and 129 pretty well but by the time we get to the recievers the signal is pretty low. Winter weather is...

Thanks Randall, that may explain some of the issues he has had with his 622 over the months. The 44 is outside so I should be able to put the power insterter inside on port 1, right? Thanks again.

The old part timer has installed several DPP44's and always used the power unit provided. The other day I was servicing a site that had a 500 and a 300 running into a 44 but the 44 did not have external power. The switch was feeding 4 receivers, some of them dual and everything was working fine...

Thanks folks, my hangup is that I thought I read somewhere that you should not exceed 80 feet from the dish to the DPP44. This application should be about 140' to the media center so I will try it.

Does anyone know of a splitter that will accept the stacked signal from a 1000.2 dish and distribute it to 4 recievers? If I run 3 RG6's to a DPP44 I exceed the length requirement before I reach a point to power the DPP44. Sorry I'm just part time.