Recent content by jon6569

Thanks, Scott. I've tried that and all the other 0775 codes, none gain control of the 811. Anybody have advice on exactly where to put the IR on the Replay and in what position? Jon

I've looked at the threads regarding Replay and the 811 and I'm still not able to control channels on the 811 with Replay. I have a Replay 5504 and am using the IR blaster. I'm running RCA cables from the 811 to Replay. I've moved the IR blaster around quite a bit in case that was the...

Doh! Thanks, Kent! Gosh, that's dumb of me, but for whatever reason I kept closing that screen. It worked fine once I did all the remote steps at the same time the info screen was up. Thanks again, all. This is a fantastic forum. Perhaps down the line I can help someone as lost as me... Jon

Thanks, Bobby. Yes, I've brought up the Sys Info on both the 811 and 522 TV 2 and it shows that everything's on Address 1. It doesn't seem I can do anything in this screen, that it's just informational. Jon

Well, I already figured out the answer the #2. In the manual, even, so that shows my impatience. If you hit the star key (*) it toggles through the screen modes (stretch, zoom, grey bar, etc.). So, I found the right optimization for HD 16:9 proper viewing, and then have to deal with bars on...

Two questions in one: 1) I have a remote control conflict between my 811 and 522 (TV 2). I've gone through the book's step-by-step to change the address on both the 811 and also on TV 1 and TV 2. I can't get a new address to stick on any of them. (hold down SAT, enter new number, pound...

Hey, you folks are fantastic. This information has been extremely helpful! Last question, will TV2, with RG-59 coax, have a signal that's noticeably depreciated, or is that impossible to know until I see it? j.

thanks! Thanks ShadowEKU! Again, this is a great site because of folks like you. So, if it's RG5 or something like that (it's hard to read) I probably need to run new coax? j.

Sorry about the simplicity of a question that must have been answered endlessly here but I can't find the answer in my searches. This is a great site with friendly help - thanks in advance. I'm getting the DVR 522 installed in a couple of days and want to do any pre-wiring of my house that...