Recent content by JRL

  1. J

    Missing locals on HD

    I have a question for the group which is not quite a Voom problem. I have a Tivo HD receiver and two basic direcTV receivers. I had a clip on off/air on the 3 phase dish. The lines go from the LNB to the diplexer on the back on the dish then down to four other diplexers behind the receivers. On...
  2. J

    Missing locals on HD

    Only 20 miles. I am wondering if its posible to check the VSB side (RF) input for the locals by hooking a Voom box up. I now the satellite side would not come in because its the wrong satellite but if the RF side did come in on the Voom box that would tell me that its the DirecTV receiver...
  3. J

    Missing locals on HD

    A Terk clip on that has a diplexer on the back with 4 in's and out's. There are four inside diplexers but only one is needed for the HD so the fourth diplexer only goes to the second Sat in.
  4. J

    Missing locals on HD

    Hi I have a DirecTV HD receiver model HR10-250 with two basic receivers. On the dish is one of those clip on off/air antennas, on the two basic receivers I get locals from channel 5 up 2 and come in poorly. On the HD receiver I get no local HD. I have a diplexer behind the receiver. When I...
  5. J

    Two Dish Setup

    I have not seen a stand alone triple muliswitch just the old 2X2's they require two dual LNB's one for the 101 and the other for the 119 with two ports each the 110 I believe is cut in to the 119 with a special LNB and switch. Are you saying that there is a stand triple and would that mean the...
  6. J

    Two Dish Setup

    Hi I have a question for the group and I hope you can help me. I have a lot of trees surrounding my house. I am not able to use one dish for all the 3 satellites for DirecTV. I currently am aimed at the 101 Sat. I just bought an HDTV and HDTV Sat receiver. I am able to get the 110 and 119 sat...
  7. J

    Voom and MyReplayTV

    Does anyone know if Voom is compatible with MyReplayTV. Even just the Non-HD stations. Thx Jake
  8. J

    CM4228 Pre-amped

    Has anyone tried putting a channel master pre-amp on a CM4228 8-bay. On the packaging of thier pre-amp it claims to increase something by 20 times. I just got a quick look at it in the store so am not sure what it increases by 20 times. I am looking to pick up sutro tower in San Francisco. I am...
  9. J

    Missing channels

    I have a problem with some of the channels, all over 271 can not be viewed. Any ideas. Jake
  10. J

    Diplexor must be installed because of powered antenna? (Depends on antenna model)

    Did a service call the other day , the problem was some of the channels were not showing up as the right call numbers. Replaced the multiswitch and all the channels were back as the right channel numbers.
  11. J

    VOOM Installations

    Who was your Installer? I work for the company who installs in your area.
  12. J

    VOOM Installations

    San Jose Install Who was your installer?
  13. J

    New software with installation wizard

    I work for install inc.
  14. J

    New software with installation wizard

    Anyone hear of the receivers now being shipped with the new software which has something called "installation wizard" which is suppose to speed up the activation process , it also comes with off-air scanning instead of mapping. Voom is suppose to be requiring all dealers to report back with all...