Recent content by mickey53usa

In reviewing the documentation that came with my two new Wally receivers, I saw that it mentioned being able to get apps for the Wally. I have been unable to find a list of these apps. Specifically I am looking to see if there is an app for Amazon Prime Video.

Well, I finally got this wired per the below diagram and, it did not work. Both receivers showed to signal detected. - Using the DPH42, going to the power injector, then going to a Hybrid Solo Hub 203952. On this unit I put the output from the signal injector to the ODU port and the Hopper to...

Wiring by diagram in post #16 by Hipkat - Probably cleaner to put the injector closer to the DPH 42. Looked at the DPH44 and DPH 42, in the diagram above - but that puts a lot of parts in the system.

Well, two more questions - 1) Will the Dish need to be re-aimed after the install of the DPP LNB, if I am careful not to bump the Dish? 2) How far from the DPH 42 can the power injector be? The Dish is located about 40 feet from the Hopper 3, where I had planned to put the power injector and the...

Thanks for all the help. Now I know what to purchase

So, a little unclear on how the DPH42 fits in. The Tech installed a four port device (Hybrid Solo Hub?) under the antenna. One has the LNB cable going in and one has the cable to the receiver (Hopper 3). Two are capped. The DPH42 (not sure which one as I have found several) must go after this...

Thanks for all the responses - I'll let things settle a couple days -

Searched and could not find an answer - Just had installed a Hopper 3 (see other post) Need to move recordings from 722. Moved them onto an external HD (EHD). Now, how do I get them on the Hopper 3. The installation Tech basically said - good luck, that as soon as I plug the EHD in, the Hopper 3...

So, for the DPH42 - Is this what I need? DISH 2-Way Stackable Splitter for DPH42 Switch (Lifetime Warranty) - "Allows multiple Frequency Shift Keying (FSK) and Time Division Multiple Access (TDMA) enabled receivers on a single DPH feed from a DPH LNBF or the new DPH42 Switch Reduce cable...

Well, The Tech did not have a DPH42 switch. He had the DPP LNB. I told him that I would probably change to the DPP and DPH42 at a later date. Now to get the recordings from the 722 onto the Hopper 3.

OK, Technician scheduled here within two hours - So instead of the Hybrid LNB, the Tech would install the DPP LNB and a DPH42 switch, and I could then replace the 211K with a Wally. The Wally should then work with the Winegard Travl'r on the Motorhome. - Have I got that correct??

So, what receivers will work with the Hybrid Antenna and the Winegard Travl'r on the Motorhome?

After agreeing to an upgrade to a Hopper 3 DVR, and promised the new antenna would indeed work with the Hopper 3 and the 211K. The technician coming today told me that no, the 211K receiver will not work with the Hybrid antenna that he is putting up for the Hopper 3. He stated I could leave the...

The way I have been treated on an upgrade - just today - This 18 year customer is getting real close to pulling the Dish plug

Voyager6 - Western Arc - Joegr - Thanks - Don't like the thought of crawling through the attic again to put new coax in place DWS44 - Good to know - Just plan on the Hopper and the 211K, which may get replaced with something else as it travels in the RV when needed. Another ?? Can I dump...