Recent content by mo59

  1. M

    Can't get the od transponders on 110 after installing a Super dish repositioning kit

    Folks, It was a faulty LNB. I swapped it with a good LNB and I am getting both odd and even transponders now on 110. Thanks for all your help.
  2. M

    Can't get the od transponders on 110 after installing a Super dish repositioning kit

    Hi Kb2vgp, Thank you for the suggestions, I'll try them and will let you know. Much appreciated.
  3. M

    Can't get the od transponders on 110 after installing a Super dish repositioning kit

    Hi Topcat0399, I am using the Dish Network 148328 SuperDish Dish500+ repoint kit with 129 Bracket. The middle LNB gets both 119 output 2D and 118.7 on 1F. There is a DP LNB for 110 and I added a DP dual for the 129 using the additional bracket. I think I need to reaim and see what I will get...
  4. M

    Can't get the od transponders on 110 after installing a Super dish repositioning kit

    Hi Boba, I did more testing today. Let me shed some light on my previous setup on 121. I used to get the 119 and 110 using the 121 superdish (after Dish stopped using the 121 for international) and the international from 148 using a dish 300. The three LNBS are connected to a dp 34 switch...
  5. M

    Can't get the od transponders on 110 after installing a Super dish repositioning kit

    I replaced the Super dish 121 LNBs with a repositioning kit. I locked 119, and 110. The check switch on a 322 shows that all LNBS are OK with odd and even polarities. When I check the signal strength for the 110 the even transponders are green (58-70) the odd transponders are either missing or...
  6. M

    121 satellite setup help

    Thanks goaliebob99, I'll try your again tomorrow since it is already dark :).
  7. M

    121 satellite setup help

    I am sorry it PSB nor PBS.
  8. M

    121 satellite setup help

    I posted this question in the FTA section, PBS and Iceberg answered my initial questions about using the elliptical dish for 121, but I think it fits here. Currently, I am using an elliptical Hughes dish (21" x 36") with a circular LNB to get the dish network international from 148, I am getting...
  9. M

    Hughes elliptical dish and FTA

    Thank you so much Iceberg, I'll keep you posted after I finish with the installation.
  10. M

    Hughes elliptical dish and FTA

    Let me clarify, Now I am using that dish with a circular LNB to get the international from 148 and a 3800 receiver using a sw21. I am thinking of replacing the circular LNB with an FSS LNBF using the 21"X 33" dish and adjusting it to face 121 I was wondering if any one have done that before and...
  11. M

    Hughes elliptical dish and FTA

    No haking intentions here. I just wanted to ask if I can attach the Hughes dish (21" x 33") using a FSS LNBF to my Dish 500 so I can get the international on 121 and any futre FTA on 121. Thanks.
  12. M

    Hughes elliptical dish and FTA

    What did I do now!
  13. M

    Hughes elliptical dish and FTA

    Pete, Thank you so much. I'll get a 30" dish. I will see if it will get the echostar on 121 too. Thanks
  14. M

    Can I use My Direct Tv Dish with Dish network service?

    Actually I have been using it to get the Dishnetwork 148 position using only the middle LNB and an SW21. I get a signal strength of 97.
  15. M

    Hughes elliptical dish and FTA

    Hi Folks, I have an old Hughes elliptical dish (similar in size to the superdish) can I use it with a linear LNBF to receive the FTA and also Echostar on 121? Any help or suggestions would be appreciated. Thanks