Recent content by ProInstall

I want to use one line with SWM and also backfeed on the same line. The Picture looks like you would be running 2 satellite receivers? Like the Previous post, I would assume you would need 2 Diplexers to use the single wire as a Sat Feed AND a backfeed?

I recently had a customer that was on 61.5 with a Dish 300 legacy. She needed to be migrated to the 118 bird. She only was receiving International programming. A buddy of mine said to use the dish 500+ and just run the 118 to her receiver and keep the switch from the dish. I wound up...

Sorry...Dish still charges you a monthly "rental fee" if you own or lease the reciver. A better name for the fee should be a "Monthly Programming Mirroring Fee" I doubt Dish would come out and do the Install, but i would reccomend finding a good local dealer. You can either look in the yellow...

So when I order 722's in the future I should specify 722dn or 722k and that should avoid this problem?

So when you get 12 on a check switch...do you let it go or do you reset and try again until you get 3 or 4? Also...What would happen if you were supposed to install a Dish in the Eastern Arc and instead decided to Install it in the Western Arc and did not tell anyone...would it still operate...

I just spent the whole day messin' around trying to upgrade a customers (2) 625 receivers to (2) 722's. I could not get the 722's to take software downloads. :( 1st) The check switch always came up 1 of 12 and not 1 of 3 as I usually get with a dish 1000.4. I thought that IF the Receiver see's...