Recent content by rhltechie

thank you! you were exactly right. i had tv2 on the output channel from the first tuner not the second. thanks again!

Hi all, I haves vip722 that I have been running in dual mode for some time now. All of a sudden a few days ago I noticed remote 2(UHF) would notchange the channel on tv 2. Well I thought it was the remote addresses so I changes the second one. Well then inoriced that the remote would turn the...

The tv is cable ready, and yes it uses a coax connection. i am only saying that it has no "menu" like the newer tvs, so there is no option to switch from cable to air so therefore I cannot switch it to air. it is what it is, which is apparently cable as the air function does not work at all...

Hi All, The cable to TV2 is a home run to the outside junction. Also, if this was the issue, I would have thought I would have noticed this before when I had TV connected to a standard receiver. There was no fuzz with that setup. The power injector is located on the port where my 612 is...

Hi All, I have it hooked up exactly like this. I actually had reversed the SAT and ANT cables on the diplexer connected to the DPP444 and of course...i got nothing but snow. i realized what i had done and made the change. now I get the picutre...its just..well...as I have stated..fuzzy! :)...

thank you for your replies. This is the case with my 722, i apologize. I do know the difference between a splitter, seperator and diplexer. I used the terms interchangebly and apparently confused many. Let me say this, the 722 setup was intially set to support a second tv off of the second...

thanks for all of your replies... "but you'll need to figure out where the other diplexer" there are two behind the main tv with the 722... "so next, i plugged a cable into the sat port of the splitter thats connected to the distribution port and connected it to the second tv and there was...

ok, specifically the 2nd tv is the one that is fuzzy. when i say fuzzy, it's a snow look. kind of like if you were using an OTA and the signal wasnt coming in great. I was not expecting any HD quality on the 2nd tv, it is a VERY old small 13 inch SD tv that I just watch in the kitchen. "Try...

Hi All, Here is my situation, hopefully someone can help me out. i originally started out with a 722 that controlled my main tv and a second tv...well i got a new second tv that was HD so i got another receiver, the 612 so i could have HD on the second tv. The setup to control a second tv was...

Hi All I have been lurking for a while and have gotten quite a bit of valuable info from the group. now I have a question that sparks my interest to get involved! great forum!