Recent content by rumi

Will the 119 still work after the swap? What about all the channels on 121, are they on 118?

Thanks for the Info.

How much cable can be between the DP34 Switch and the DP LNB? Currently the switch is located on the pole of the dish. I wanted to move it and run cables from the new position of the switch (about 150' away) to the LNB.

What would the settings on the receiver look like? Can I use a Standard 4X1 switch?

The problem I was having was due to insuffecient power to the Dish Pro equipment. If you plug in your DP receiver to the switch, it will power the DP equipment and you'll get a steady signal.:up

Great, Thanks for everyones help.:up

Ok, thats good to hear. Any reason why a DP LNBF would give me fluctuating signal strength?:confused: Can I use it with a DP34 switch?

I added you to my yahoo Messenger. My ID is madaripur@yahoo.com. How powerful are these Twinhan cards? I have about 150 ft of cable between the card and the dish. Just to be safe I added a inline satellite amp. I still have no luck. Can it be the DP34 switch?:confused:

Thank you guys very much. I followed the directions and it worked very well. I used the FSS or 121 to align the dish and it aligned 110 and 119. How many receivers can I connect using the dp34 receiver? I assume 4 but I don't know.

Ok I'll try that and let you know of my findings. Thanks.:up

Before finding the dishes, If I ran check switch shouldn't it tell me that the LNBs are connected and to which port? The problem I have now is that, I connected 110 to port 1, 119 to port 2, and 121 to port 3. When I do a check switch, I get: Port 1: Dual LNB Port 2: No Connection port 3: No...

Yes, sorry for get to mention that 110 was on port 3 of the dp34 switch. I have tried to switch the ports so 110 is on port 1, 119 is on port 2 and 121 is on port 3 but no luck. When I run the test I get 110 is connected and is a dual, port 2 no connection, port 3 no connection. And yes, 110 is...

I have a superdish 121 connected to a dp34 and a 301 receiver. When I do switch test I get port 1 and 2 as "no connection". The single dp LMB connects just fine. Could there be a problem with the 119 and 121 LMBs? I tested the voltage at the LMBs and got a 18V reading, therefore it is receiving...

Right now I just want to get something, to make sure the card works. I'm aiming for 110 because the dish network receiver was connected to it and the dish is pointing to 110.

I have a 1022A card that I am trying to getto work with my dish pro LMB to receive FTA signals. I have tried many settings with the same result. I get a fluctuating signal bar with 0% quality. I tested it with my Dish 301 receiver pointing at 110 and get around 80% signal. But when I plug it...