Recent content by thaar

Thanks for the replies. I've tweaked with all of the settings on the box. Sounds like it's the box. Not that big of a deal since sound is going through the TV. I'll just use the L/R audio cables.

I moved my VIP622 from my home theater setup, where my receiver did all of my video and audio switching via component and toslink, to my bedroom, where it is now directly hooked up to Panasonic 42PX80U via HDMI. I have the speaker output on the TV set to on, and have messed with pretty much all...

So basically this would allow me to watch my DVR just not in the highest quality, but also give me the ability to watch everything else in HD, correct?

Unfortunately, one one TV is upstairs while the other is downstairs. I was afraid of this might happen.

I just replaced the SD TV in my bedroom with an HD plasma. My VIP622 located in my living room (for my HDTV) is also controlling the TV in my bedroom via coax. Since I really want to take advantage of HD on my new TV and coax doesn't have the capacity to carry an HD signal, I think I need to...

Here's my setup: VIP622 Older Sony 43" HDTV 4:3 Denon (does my video and audio switching using component video and fiber cables) Problem: I cannot get the 4:3 to fill the entire screen. I have a black frame around the entire image, no matter what setting I set the 622 to. I recall...

Been lurking here on and off for the past few years and finally had some questions. I had Dish a few years back and really liked it. However, Comcast came around and gave me an offer that I would have been crazy to pass up. Now Comcast is a little too expensive and I liked the PQ better on...