Search results for query: *

Thanks Iceberg, but I do not understand when the choices on the sonicview setup screen for the type of lnb setting is either OSC,Single or Universal. When it is set on universal the setting is automatic on the 9750/10600 and cannot be changed. The 22khz switch is set to auto. If I choose the...

Hi I could use some good advise on getting the right LNBF.The new BSC621-2 that I put on my 6 ft. Dish does not work on Ku band. I am using it with the new Sonicview 8000HD. May be it is just defective and another bsc621-2 will be o.k. I see on the internet that there is also a bsc621 lnbf...

Hi Good to have some feed back,I appreciate your help. I have a 6 ft. wire mesh dish with a DMSI BSC621-2 LNBF and using a General Instrument 350i receiver to turn the dish.

sonicview8000HD CHANNELS Hi Turbosat Yes the receiver came with a list,no revized satellite names ,thats ok. I did a blind scan. I am not getting the channels that are listed on different sites for each individual satellite. For eg. on G16 there is the Shepherds Channel Network,( which I get on...

How To? Channel List Hi I feel like a fool about this question, because I did not get a channel list, I downloaded the channel master. But this is all part of learning . So let me see if i can get instructions to get the real Channel bin file for the sonicview 8000HD. I have looked at all sort...

Hi cigarman Sorry I cannot help you. But if you start a new Thread and ask your question I am sure someone will help you. This is a very friendly place to get help. So have fun,I am new at all this myself. hans

Hi I hope someone could help me to get the right channel up date list and then lead me through the steps to install them on the sonicview 8000HD. I downloaded the list that Iceberg refered to as the newest list, but I cannot install it. So if someone would be so kind as to help me I realy would...

Thank you very much four zeros did it. Would you be able to help me to get the new update satellite & channel list installed on the sv8000hd. Check original post. thank you.

Thanks,I tried that, but no success. When I select the factory reset it comes up with bar that has a key and four - - - - That is what I get. No change in the channels. So I know not what is going on. May be some body does.

Hi I am trying to edit channels from AMC 1 . Cannot delete any channel. I went to factory reset and that only deleted Channels from another satellite I had, but did nothing to change the channels that are in the AMC 1 . I want to clear the list and install a new updated channel list. I tried to...

Hi I have a 6' mesh dish with an actuator arm being run by General Instrument super 350i receiver. I am using a DMSI BSC 621-2 LNBF connected to the Sonicview 8000HD & on the IF out I am going to the General Instrument super 350i for signal. Can someone help me to set the satellites on the...

Thanks to everyone for your help. It is the TV that causes the problem, changed monitor and there is the menu bar in full. hans

Thank you,that worked but it did not change how the menu bar is positioned. is there a fix for bringing the menu bar up. hans

Hi I have a Sonicview8000HD receiver that I am trying to upgrade the software,but when I bring up the menu for the USB stick I cannot read all of the menu Bar because it is too low on the screen. How can I get the menu Bar up to read everything . hans

Hi I have just got a sonicview 8000hd I am trying to set it up have never done this.