Social Feed

JAS
JAS
Last reply · posted in Free To Air (FTA) Discussion
My setup is per the attached with a 4DTV DSR922 and a Pansat 9200HD with the -S2 board. The splitters have DC blocks on the MPEG Receiver side.

The problem I have is associated with the DiSEqC switch. For some time I have not been able to get a strong enough signal to lock the LPB stations on AMC-21. I decided to change out the DiSEqC switch. When I installed the new switch signal went up to 80 and quality went to the low 90's. I thought this is great, But, when checking other satellites find that I lost some C band -S2 signals.

I have 4 DiSEqC switches 2 2 port and 2 4 port. I do not know the brand of any of the switches, all the tags are gone. When I use either of the 2 port switches I gain the LPB signal and quality but loose signal and quality on some C bald -S2 signals. When I use either of the four port switches I loose signal and quality on the LPB stations but gain back the -S2 signal and quality on C band. I have tried switching ports but is always the same.:rant::rant::confused:

Any suggestions:confused:
15 Replies · 2260 views
P
You are likely having signal level problems. The Pansat 9200HDs are a bit on the deaf side. A low-loss 22 kHz switch might solve the problem, but it's possible a couple of good quality amplifiers at the dish will be necessary.
JAS
JAS
You are likely having signal level problems. The Pansat 9200HDs are a bit on the deaf side. A low-loss 22 kHz switch might solve the problem, but it's possible a couple of good quality amplifiers at the dish will be necessary.

This only occurs With the LPB -S2 mux On AMC-21 and another C band -S2 mux on an unmentioned satellite (not in The List or Lyngsat). I get C band and KU satellites from 50 degrees West to 139 degrees West and only those two muxes act like that. I'm stumped. :confused:

Thank You
L
Add the switch, then check - note Quality readings
Remove Switch, add 1 Splitter and 4DTV - Check C Band, then Ku - note readings
Try the second splitter
See if you can narrow it down to 1 switch / splitter or combination there of.
JAS
JAS
Add the switch, then check - note Quality readings
Remove Switch, add 1 Splitter and 4DTV - Check C Band, then Ku - note readings
Try the second splitter
See if you can narrow it down to 1 switch / splitter or combination there of.

I'll have to try that later. Need to get on the road.

I'm starting to think that this is just another of the many Pansat software problems.

Thank You
L
I'm guessing bad / poor splitters.
P
This only occurs With the LPB -S2 mux On AMC-21 and another C band -S2 mux on an unmentioned satellite (not in The List or Lyngsat). I get C band and KU satellites from 50 degrees West to 139 degrees West and only those two muxes act like that. I'm stumped. :confused:

Yes, S2 is very touchy and susceptible to low signal levels on the Pansat 9200HD, particularly with the old S2 board. The new S2+ board is much better in this respect. The cure is normally to get a hotter level into the receiver. There is the lesser possibility that your LNBs have a bit too much phase noise for reliable S2 reception, and inserting anything into the signal chain cuts your margin to razor thin levels.

I would start with getting your signal levels up. It's cheap and should improve the 9200HD performance all-around. Replacing LNBs is usually more expensive.
JAS
JAS
Bingo

I'm guessing bad / poor splitters.

inserting anything into the signal chain cuts your margin to razor thin levels.

My splitters did not have a built in DC blocker. I was using a F type attached to the splitters. I found splitters with the blocker built in this fixed the problem.

Another problem I was having is when the temp drops below 20 degrees F I lost all -S2 signals and all KU when it dropped down somewhere below 0 degrees F . I not asking for it, but it would be interesting to see if the blocker caused that problem too. The normal low temp around here in the winter is in the low 20's so this is not a biggie. It's just been unusually cold.

Thank You

PS Good thing this is a hobby. I would not go through all this just to watch TV
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68664 Replies · 2680695 views
  • Like
Reactions: c-spand
sdfntx
Take It as It Comes - Steve Winwood
  • Like
Reactions: EatMyVolts
long_time_Dish
Take The Money and Run - Steve Miller Band
EatMyVolts
Run Joe -- Louis Jordan and his Tympany Five
  • Like
Reactions: Bobby
long_time_Dish
The Long Run - The Eagles
  • Like
Reactions: ClarkGable
ClarkGable
Long Train Runnin' - The Doobie Brothers
meStevo
Lifetime Supporter
Last reply · posted in TV Shows
Starting a thread klang !

After an amazing first 2 seasons and an 8 episode 3rd season still coming this year, season 4 has now been greenlit.

Keri Russell Wow GIF by NETFLIX
12 Replies · 1035 views
  • Like
Reactions: klang
K
Finished season 3 last night. Still one of my favorite shows.

Anyone else wonder if there might be something else going on with Callum? Seems to me he has too much access to Russian intelligence.
meStevo
One episode into season 4 that dropped today...

Jon Stewart Popcorn GIF
  • Like
Reactions: NYDutch
meStevo
Renewed for season 5.
  • Like
Reactions: NYDutch
K
Finished 4 last night. Great stuff.

They do like to end each season with a Bang!
KAB
KAB
Finished 4 last night. Great stuff.

They do like to end each season with a Bang!
Great ending, but it ran in circles most of the season.
M
Last reply · posted in DISH Network Support Forum
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
5 Replies · 222 views
Almighty1
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
I have a DISH Hopper 3 (Software H713) with Hopper Plus (Software P15403). I have not tried streaming services but I primarily watch TVB Jadeworld international package which is only available by streaming and when I have an issue, I usually have to go to a non-streaming satellite channel first before the streaming channels will work again. What software versions do you have and what is the error message if any are showing on your screen? or is that Dish downloading logo just stuck and never finishes?
  • Like
Reactions: charlesrshell
M
I have a DISH Hopper 3 (Software H713) with Hopper Plus (Software P15403). I have not tried streaming services but I primarily watch TVB Jadeworld international package which is only available by streaming and when I have an issue, I usually have to go to a non-streaming satellite channel first before the streaming channels will work again. What software versions do you have and what is the error message if any are showing on your screen? or is that Dish downloading logo just stuck and never finishes?
I'm on H713 on the Hopper and P15403 on the Hopper Plus. It shows internet connection issues and doesn't finish loading the various services. I see the "loading circle going around. Sometimes I get a message saying that the service is having trouble loading my content and to check the internet connection.
  • Like
Reactions: charlesrshell
Almighty1
I'm on H713 on the Hopper and P15403 on the Hopper Plus. It shows internet connection issues and doesn't finish loading the various services. I see the "loading circle going around. Sometimes I get a message saying that the service is having trouble loading my content and to check the internet connection.
Did it ever work correctly before? Hard to say what the problem is. Usually for streaming, it will show the Dish logo with lines sweeping down to show downloading, never seen the circle issue. Did you try a manual reboot, red button reset, power cord unplug/replug to see if it makes a difference.
  • Like
Reactions: charlesrshell
S
Did it ever work correctly before? Hard to say what the problem is. Usually for streaming, it will show the Dish logo with lines sweeping down to show downloading, never seen the circle issue. Did you try a manual reboot, red button reset, power cord unplug/replug to see if it makes a difference.
Might be worth just to ditch the hopper plus. No issues here on h713
  • Like
Reactions: charlesrshell
S
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
Buy a roku and dump the hopper plus you'll be better off. If you have a smart tv you don't need either one. No hopper plus here and no issues!!!
  • Like
Reactions: charlesrshell
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 16 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 1 views