OK, this thread is for DirecTV installers. We all hate the fact that they make us run phone lines for free, but that isn't what this thread is about. I have heard a few tricks to get around the system and would like to verify a few of them and hear some new ones. Im sure most of us could use better responder stats, I know I could.
1. If you activate a receiver using the order id box on the receiver, and a phone line is connected, it will count as a responder right away and you will get credit for that receiver right when it activates.
2. If you activate a receiver and then initiate a self-test with a phone line installed, that receiver will count as a responder right when you do the self test because it pings the phone connection.
3. We should all know this one, but in a SWM install, you only have to have a phone line connected to the PRIMARY receiver, it can even be a standard, as long as it is the primary.
Now, I know #3 is true, but I would like to know if #1 and 2 are correct. Also, I have tried activating through the receiver using the OMS order id with a phone line connected a few times and can never get it to work, anyone have any luck activating that way? By the way, I always check phone jacks with a tester, so its not that the phone jack wasn't working or was reverse-polarity.
Also, anyone else have any other tricks for getting better responder rate(other than running home runs to the nid and leaving 25' jumpers laying accross the floor)?
Thanks