Correction to my own stupidity...
nicholassjenkins said:
I currently am using a Diplexer (and crappy Terk 42 ;-), so I know this *can* work.
While the above statement is true, it occurs to me (after finding 1 errant, but related article tonight...) that I currently have this strange interaction when tuning to OTA channels on my 6000... I oscillate between no signal and excellent signal, every time I press the Guide button, meaning:
State 1: Fine OTA signal.
Change: I press the guide button, then select some OTA channel.
State 2: No signal.
Change: I press the guide button, then select some OTA channel.
State 1: Fine OTA signal.
rinse and repeat...
I always thought this was a bug in my 6000 receiver, but I would now guess that each time I go to the "Guide", it is toggling between the 2 inputs on my SW21 switch. Thus, as my TV-42 is only connected to 1 Satellite input, every-other switch gets me dead-air. Duh...I actually feel ashamed...this should have been so obvious.
So, the big question is...later today when I swap out my 6000 with my 921, and I migrate from Dish Legacy to DishPro, will my new DP34 switch pass VHF/UHF signals, if they are being fed from my TV-42 in on both my 110 & 119 feeds?
Once I test, I will post and let everyone know. The good news would be that if that works, it would be less effort to buy a crappy TV-44 and connect 110, 119, and 61.5 through it into the DP34/SW34 than to run an OTA connection in, then run it through a pre-amp, a splitter, and a wild series of diplexers. However, I would bet that even if the signal will pass through the 34 that it will not be able to drive the maximum of 12 receivers that the 34's can cascade to feed. But, maybe it could drive the 3 tuners that I'm interested in ;-)
After I test, I'll post.
-NICK