Tried again. Can't seem to figure it out. According to the signal meter I'm using (Signalcat I think), there's nothing else nearby.
Sorry too hear that the install process is proving a challenge!
If you are trying to locate the satellite using only that analog meter, be prepared for a long and difficult process. A SignalCat meter only detects that the dish is aimed at 1 of 30+ satellites visible from your location. It does not confirm what satellite or if the LNBF skew is properly set. You need to have a small TV with the Signal Meter displayed at the dish. If you do not have immediate feedback on the Signal Quality readings, you
will not be successful. It is next to impossible to set the dish aiming without watching the receiver's signal meter.
You indicated in one post that you were getting a Signal Quality reading on channel 901, but no video from the channel was displayed in the background. As rv1pop suggested, you were simply on the wrong satellite. It is possible to get a false reading with no programming if the LNBF skew was not properly rotated and the dish was aimed at another satellite that is 10 degrees to the west of the correct position. If you get a higher and fluctuating Signal Quality reading that does not turn green and no live programming is visible behind the meter, the dish is likely aimed too far to the west. If you compare where the dish is aimed to the compass reading that was provided with the system you will note that the arm is not close to the suggested reading. To get to the correct satellite from your location, increase the elevation by 1 or 2 degrees and pan towards the east approximately 10 degrees.
Did you check the dish for warping or shipping damage prior to assembling? This cannot be done by using only your eye. Check out page 35 on how to perform a string test to see if the dish is perfectly shaped.
So it appears the answer is that if and when ever I get the dish properly lined up on the satellite, that I should actually see a picture on channel 901? That's very helpful. Would have been even more helpful in the instructions.
According the installation instructions in the Owners Manual on Page 47 paragraph 4, " When the correct satellite is found the beeping sound changes to a higher tone and the
Signal Quality (Q) bar turns Green. The meter will display an increased Signal Quality (Q) reading.
RT News Channel programming will be visible." A Signal Quality reading of at least 50% with TV programming visible in he background will be needed on channels 901, 106 and 113 before performing the Channel update on Page 49.
I would suggest performing a factory reset on the receiver and reactivating in Glorystar and use ONLY channel 901 to locate the satellite. Set the LNBF skew to +14 (CCW standing in front of the dish) and the receiver to Channel 901. You are on the right track, but first concentrate on receiving channel 901 then everything else will hall into place. The special advice that I have for you is...... closely follow the instructions starting on page 47 with a small TV next to the dish and continued patience.
You may also call our support team at 866-597-0728, M-F, 7:30am-4pm, PT if you need additional assistance.