Going to be drastically changing my system up in the next two weeks.
For a long while I have had huge Klipsch towers and the center (RF7II and RC64II), but I find myself wanting a little room freed up, and maybe something with a less in your face horn. Plus I never do 2 channel music any more either. So, the shopping began, and Ill start with saying speaker shopping sucks...
Original HT Setup:
Marantz AV7702II
Outlaw Model 7140
RF7II's
RC64II
Rythmik FV15HP x 2
After looking around at what could replace what I have, handle high volume HT levels, and not break the bank, I settled on the Power Sound Audio MTM-210 for my fronts and the MTM210C for my center (slash tv stand

). Also, needing Dolby vision pass thru, I am selling the Marantz AV7702II and have a Yamaha A3060 arriving today. The PSA monitors need little power to play LOUD, so I can also sell my Outlaw amp and free up more room.
The final thing this allows me to do, is spread the subs out more. I know the farther they are apart the better, I proved it with REW, but due to the huge Klipsch towers the subs are cramped closer together. After speaking with Tom at PSA, I am going to place the MTM210 monitors on the subs with an isolation pad, so I can spread the subs out farther and then just toe the speakers in as needed for the MLP. The A3060 will drive these 3 speakers fine, so I don't have a large area of my stand tied up in an amplifier. The center is huge, its basically the same as the two monitors set to lay down (I've never owned a true LCR setup before in this manner), and I can place my OLED on top of it without issue. My HT stand is only 17" tall, I like the display to be as low as possible.
Final setup:
Yamaha A3060
PSA MTM-210's
PSA MTM-210C
Rythmik FV15HP x 2
I'll post some updates as I get it all in and try it out. Going to use the Sorbothane pads and feet they sell on Amazon in all kinds of sizes, for the MTM bases.
- 2 way, audiophile loudspeaker
- 1" titanium compression driver
- Cast aluminum exponential horn
- Dual 10" high efficiency woofers
- Audiophile grade crossover completely designed in house
- Frequency Response = 70Hz - 18kHz
- Sensitivity = 98dB 1W/1M
- Nominal Impedance = 8 Ohms
- Power Handling = 175 W
- Size HxWxD = 11" x 28" x 16" (includes grill)
- Weight = 55lbs
Also nothing wrong with good ole made in the USA speakers.