caller ID on screen w/phone AND ethernet?

[cparker]

I just noticed I have no caller ID on screen any more. It's enabled in my settings on the receiver. Then I remembered that I connected both receivers to the network so I could play with the online access to the DVR and stuff. BOTH receivers are STILL connected to the phone line.

Does enabling them for network stop the caller ID from showing up even if you left them connected to the phone?

Anyone else seeing this?

Or did I miss a step somewhere?

 

[TheKrell]

Mine still works.

 

[Bobby]

Mine still works as well. Have you tried a comm check to make sure that the receivers have dial tone?

 

[Bradtothebone]

Mine both work that way, also.

 

[cparker]

weird....

I went through and ran every test I could find and ..... it's working again.
weird.... just very weird

 

[tlc1145]

Make sure that you have the caller id activated for both rcvrs if you are using ViP boxes. I've had problems in the past where one is activated and the other one isn't and it stopped the caller id from working on both.

 

[KAB]

Make sure that you have the caller id activated for both rcvrs if you are using ViP boxes. I've had problems in the past where one is activated and the other one isn't and it stopped the caller id from working on both.

Just one of two enabled here. Works fine.