Dish 1000 and Adding 61.5

hilljec

Member
Original poster
Jul 11, 2004
13
0
Is it possible to add 61.5 to the input on the DP Plus Twin where the 129 connects on the Dish 1000 and then connect the 129 straight to the 622? I was wondering if there was a solution without using a switch.

Thanks,
JEFF
 
No, you will need a DPP 44 switch to connect all 4 sat locations and will need 4 lines running from the lnb's to the switch, one for each sat location.
 
Your question is actually a little confusing!

The answer above is correct if your intention is to have all FOUR satellites orbits covered and connected. Get a DPP44

But if you mean to substitute a 61.5 dish for the 129 signal, that is possible without any more equipment.
 
abricko said:
using a DPP44 and a 4 Dish setup, you would still need to run 2 lines from the DPP44 to the receiver (622). You couldn't use the separator and one line (output) from the DPP44?

A single coax from the DPP44 to each receiver location. With dual tuner receiver like 622, a separator is used at the receiver location to feed the two tuner inputs off of the single coax feed.
 
Correct, you can just run 1 line (with the separator) from the DPP44. I am doing it to all 3 of my receivers right now (622, 942, 322).
 
***

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Who Read This Thread (Total Members: 1)

Latest posts