Dish 500 Troubles

[chronlc]

Hello,

Im running a dish 500 with 2 single lnb's, these lnbs on the side say dish pro. I have a sw21 switch feeding both signals to my reciever. For some reason I can nail the 119 bird without a prob getting a 109 signal, but i cannt get a signal for 110 bird at all. I have my skew set correctly for my zip code according to the Peak Angles menu in the dish point screen. I am utterly stumped on this as I thought if u could get signal from 119 you would have signal for 110. Also when I go to the check switch menu and do a switch check all i get is:
LNBs: DP-Single
Input: 1
Satellite: 119
Polarity: ALL
Device Sgl
Status: WARNING - Only one satellite connected

Im totally stumped any suggestions or comments would be greatly appreciated.

Thanks in advance,
Chronlc

 

[chronlc]

Also wanted to add that my reciever is a DP301.013

 

[boba]

Also wanted to add that my reciever is a DP301.013

You have DISH PRO equipment but a SW-21 is for Legacy equipment you need a DP-21 switch or a DP-34 switch for the system to work. http://www.switchinfo.info/index.htm

 

[chronlc]

Thanks bro, I figured it was the switch, I had a sat fidner meter that I just used and i connected each LNB to it and had signal just the reciever was only showing 119. Thanks for the info really appreciated it.

Thanks again,
Chronlc