E* and single LNB dish with motor?

[E*Dude]

I know this is probably a long shot, but is it possible to use a single LNB dish with a SG2100 motor on a Dish Network receiver to receive 110, 119, 129? I'm not too familar with the DISEQC capabilities and if it was at all possible. I have strong doubts, but it doesn't hurt to ask.

 

[garys]

It would probably work, but you would have a lag before being able to watch a channel while using the motor. You would need to know what sat each channel to be able to point to it most time when changing the channel. The switch being used for multiple sats is a lot faster and therefore more convenient if you watch a lot.

 

[E*Dude]

Yeah, I figured there would be a tremedous delay between different sat changes when surfing. I was mainly concerned about performing a check switch, I was wondering how many sat locations would be searched during this process if it was happy with the setup.

 

[garys]

Unless you can have the receiver receive all three sats and then remove them, you would have to do a check switch each time you move the dish.