How to set up a Motorized KU Band dish

Discussion in 'FTA FAQ's' started by AcWxRadar, Oct 10, 2009.

Thread Status:
Not open for further replies.
  1. AcWxRadar

    AcWxRadar Topic Starter SatelliteGuys Pro

    Joined:
    Apr 26, 2006
    Posts:
    4,575
    Likes Received:
    1
    Location:
    40 miles NW of Omaha. Omaha?
    I composed this tutorial manual as a "How-To" for all FTA junkies to use to set up their small diameter Ku motorized dish antennas a few years ago.

    It is lengthy, but give it a read and see if it helps you with your endeavor. I think I put in some good information here.

    It is directed towards a Coolsat 5K/6K FTA receiver owner, but you can obviously adjust the specifics in menu setups to your own make and model.

    I know more now then I did when I wrote this, but I think it all still applies, I am hoping that you will find it informative and helpful.

    RADAR
     

    Attached Files:

  2. SatelliteAV

    SatelliteAV SatelliteGuys Master
    Lifetime Supporter

    Joined:
    Sep 3, 2004
    Posts:
    6,483
    Likes Received:
    174
    Location:
    Roseville, CA
    Here are the motorized install instructions that we provided several years ago for Fortec Star Lifetime Ultra, Fortec Star Mercury II and Visionsat IV-200 receivers using the GEOSATpro GS120 motor.

    Hope that these might help someone with their install!
     

    Attached Files:

  3. Wescopc

    Wescopc SatelliteGuys Pro
    Pub Member / Supporter

    Joined:
    Sep 11, 2005
    Posts:
    1,777
    Likes Received:
    69
    Location:
    Canby, Oregon
    Radar I converted your Word Doc to a PDF - it is attached for those who prefer PDF's:)
    Bob
     

    Attached Files:

Thread Status:
Not open for further replies.

Separate names with a comma.

More...