I recently got hold of a new Orbitron 10' mesh. Some hardware are missing. The most important is the intermediate hub plate. I know it will be difficult to get here. Can somebody give the dimensions for this plate. This is what I got from the manual I've downloaded from our forum:
The intermediate plate for the 10' and 12' dish has eighteen 9/16" x 2 1/4" raised "fingers" around the edge. Position the intermediate plate with the fingers down. Each finger will then engage a rib by inserting into the square rib cavity.
I was thinking that the rib will slide between a cut slot. From the description and picture, I think it will slide into the rib( not in the mesh groove). Please help
The intermediate plate for the 10' and 12' dish has eighteen 9/16" x 2 1/4" raised "fingers" around the edge. Position the intermediate plate with the fingers down. Each finger will then engage a rib by inserting into the square rib cavity.
I was thinking that the rib will slide between a cut slot. From the description and picture, I think it will slide into the rib( not in the mesh groove). Please help