Master and Slave problem.

Status
Please reply by conversation.

vargf

SatelliteGuys Family
Original poster
Nov 10, 2005
47
0
I have two receivers 1 is the Fortec Ultra life and the other is a Pansat 500CI
with double slot to put 2 PCICM cards.

but the question how to put the Fortec Ultra Life Master and the Pansat 500CI slave. any idea.



Antena1Ku-band Motorized
|
|--Switch-->MasterFortecre--->Pansat500CISlave
|
Cband big dish

I need help.:confused: :confused: :confused: :confused: :confused:
 
Last edited:
Know I have a Master and Slave receivers but the problem is when I change
channels from C-band to Ku-band When I watching C-band channels all is good but when I change to channels on Ku-band no signal for the slave.
There is a way to get Ku-band channels on the slave?


thaks:confused: :confused: :confused: :confused:
 
Problems with Master and Slave receivers

Master and Slave problem.

--------------------------------------------------------------------------------

Know I have a Master and Slave receivers but the problem is when I change
channels from C-band to Ku-band When I watching C-band channels all is good but when I change to channels on Ku-band no signal for the slave.
There is a way to get Ku-band channels on the slave?
:confused: :confused: :confused: :confused: :confused: :confused: :confused:
 
See the attached pic - it should help.

This setup is what I plan on implementing here at my place. The DVB receivers are at the mercy or whatever polarity the BUD is set to but on Ku Linear and Circular both receivers can see horizontal and vertical. If the little dish is motorized, add the motor between the receiver and the DiSEqC switch on the receiver you want controling the dish.

I got the HF splitters from Sadoun today :). I'll probabaly use whatever DiSEqC switch comes with my next FTA receiver until I can pick up a #2 DMS one.
 
Last edited:
VARGF

PLEASE keep all your posts together (and in the same area and thread)

THANKS!
 
Status
Please reply by conversation.

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)