So I did all the clearing tasks and re-initiated the drive. We'll see how it turns out. I was on the phone again today with the Lab Technician. He tried different 622's with different software versions, meaning starting with the current L4.05 and going several versions backwards to compare. Turns out that the CURRENT software has this issue, and confirmed that this is SW related. The previous versions didn't act up like that. He reproduced the problems I have. So he asked me to post this on Satelliteguys.US to inform you guys, that whoever runs into this problem, it IS related to L4.05! This means, that L4.05 seems to NOT quite like the built in switch in the new Triple LNBF that comes with the new D1000.2. Not a whole lot of subs have the new 1000.2 combined with 622 yet, and that's why there hasn't been alot of complaints yet. He confirmed that this will be addressed for a software release after the next one coming up, as more people will get the 1000.2 installed and complaints will significantly increase.
However I discovered, that leaving the receiver on an OTA channel, before turning it off at night will not cause you to wake up to a black screen next morning. Try not to mess with the point dish screen too much. IF you have to, turn it to a channel off of 119 first, and then go to the point dish screen to look up what you want. Remember the TP it was on and go back to the same setting BEFORE you exit the screen. ALWAYS make sure to press the DONE button. DON't exit by pressing Wach Live TV! I don't know if anybody with thw same seetup as mine will have the SAME exact issues, however I recommend using the sequence previously posted. This does NOT apply to users, that have additional switches installed, as the 622 communicates with these switches directly, instead of the built in switch in the Triple LNBF. These are just connected as feed to the DPP44 or others, that are installed. The Dish Technician especially monitors this thread real close right now, to see if there's more users with similar problems. So if you have a similar setup with a 1000.2 involved, and have weird problems going on, please post it here, as it will be used for further development of better software.