Viewsat Extrem
What satellites are you trying to pick up?
Let me see if I can summarize what I've done thus far. I set my eliptical dish (31") on a 7i' pole, put it on the Diseqc HH motor (SG 2100), set the dish at about 220 W to try and catch Echostar 8. Ran 100' cable from dish to receiver. Connected LNB to Viewsat Ext SW41 4 in 1 diseqc switch. Loaded receivere with current PGM after doing factory default. Set motor for longitude and latitude of zip 71603. I didn't load any other files.
Here is the set-up:
Satellite: ES 8,10 110W
LNB power off (When it is turned on the "s" does not move up but remains at 64%; the Q does nothing)
LNB Type: Legacy Quad LN B2
LNB Freq: 11260 (S and Q rise and fall to o to 100 quickly)
ddhz: off
TP freq: 12288 (both S and Q rise and fall)
search: all
Diseqc 1.0: port 3
Motor off
Legacy Sw none
F1 scan sat. Total 32, processed 32; saved; receiver shows no channels. TV shows "no TV channels"
The only settings I changed on 119 is the TP frequence of 12297. F1 and 21 processed; saved, but same coments as above.
I used a signal meter to tune to 90% on the satellite and set my dish to that area. Each time I have done this there is no signal quality that will lock. The skew angle of the LNB is counterclockwise about 5 p.m.
I have followed the directions---limited--I got from the manufacturer. I have downloaded, read and followed suggestions, but I still can't get any programming? Any ideas?