Special One-Night CE for 9/15 -- No Weekend CE's

Same here on my 500.

Is there any way to abort an update so that you don't have to wait 15 minutes for the whole process to finish?

Just reboot it again without entering the code, and it'll boot normally. Up until it gets to 96%, it is just downloading and you won't hurt anything. At 96%, the dark blue bar indicates it is erasing the EEPROM, and the bar turning back to gray indicates it is writing the new firmware in. That's where you could brick the receiver if you kill the power or reset it.
 
My HR24-100 has been stuck on 13% Complete of downloading 04D1 for about 5 minutes now..

..and as I was typing that the download switched to software 0559. Patience....
 
H21 had a 5 minute head start and the HR20 already passed it up

Sent from my iPad using SatelliteGuys
 

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)