Special One-Night CE for 9/15 -- No Weekend CE's

Same here on my 500.

Is there any way to abort an update so that you don't have to wait 15 minutes for the whole process to finish?

Just reboot it again without entering the code, and it'll boot normally. Up until it gets to 96%, it is just downloading and you won't hurt anything. At 96%, the dark blue bar indicates it is erasing the EEPROM, and the bar turning back to gray indicates it is writing the new firmware in. That's where you could brick the receiver if you kill the power or reset it.

PLEASE LOG IN TO GET RID OF THESE ADS!
 
JerseyMatt said:
My HR24/500 is still grabbing 04D1..

I am downloading 0559 to my HR24-500 now. the download started out as 04D1, but then changed to 0559.

PLEASE LOG IN TO GET RID OF THESE ADS!
 
My HR24-100 has been stuck on 13% Complete of downloading 04D1 for about 5 minutes now..

..and as I was typing that the download switched to software 0559. Patience....
 
JerseyMatt said:
Just reboot it again without entering the code, and it'll just boot normally.

Thanks! Downloading 0559 on my HR24-500 now!

PLEASE LOG IN TO GET RID OF THESE ADS!
 
I think the new software was just getting sent out to your area is why the freeze up on a lot of boxes.

PLEASE LOG IN TO GET RID OF THESE ADS!
 

CE's for Labor Day Weekend

H21 thru 25 CE for the weekend of 9.23

Users Who Are Viewing This Thread (Total: 4, Members: 0, Guests: 4)

Who Read This Thread (Total Members: 1)

Latest posts