Recent content by alarroyo

And the signal is great.

After almost a month of frustration and ups and downs finally was able to figure out what was wrong. First I changed the location of the dish to about 10 feet higher. Secondly I started comparing the frequencies of the TPs on my receiver and the ones on lyngsat and guess what they were off...

Just finished setting up my first FTA system (KU Only). I like it and after seeing what I can get on C-Band I want one. I have a Omegasat5701 receiver. Now I would like to set up a 6 footer to get C-Band (It will be dual). Do I need to get another receiver??? Can I use the existing one...

Well success, it is working. I guess it was "OE" (operator error) I sat the coordinates one degree off. Went ahead and sat everything again and now I can get a lot of satellites. Tomorrow I will continue to do manual search of satellites and channels. The only thing is I need to move it up...

Yes, you are correct. I'll try to fine tune it when I get home tonight. Thanks for all your help.

I have the WS9036 dish, Omegasat 5701 receiver and SG6000. I sat the latitude to 29.5 and the elevation I just move it until I got a good signal. The only bad thing I can only get 97W nothing else at all. I'm new to this so I don't know if I sat it right. Right know is on the roof I'm...

Success with 97W now let me scan the rest to see what I can find. Thanks.

Or according to the SG6000 Manual the Elevation angle is 60 degrees and declination 4.9 meaning that 60-4.9= 55.1. I will try this one and the one I mentioned above to see what happens.

The results are below. My dish elevation for 99W is 55.5 degrees. That means that I need to correct that to 50.6 substracting the declination angle? Am I correct. You might be right and I'm probably closer than what I think but it is frustrating. thanks for all your help. Latitude...

Tried that and it did not work. I'm puzzled.

I already sat the elevation of the motor at latitude and don't intend to move it. I'll try the USALS and have it take me to 97 W then I'll adjust the elevation of the dish and azimuth again. Will see what happens. It is a little frustrating.

I'm trying to set up my FTA system and I'm getting nowhere. I have a SG6000 motor with a WS9036 and Omegasat 5701. I'm trying to use 97W (171.4 az from here) to my system up with no joy. My coords are 29.5N 98.7W. I've tried every setting I'm given by various sites. I've sat my latitude and...

I posted this in another part in this forum, I'm new into FTA. I just recently acquired a FTA system and was wondering some tidbits to install it and get as much channels as I can. My system is WS9036, OMEGASAT 5701, SG6000 with DMX521. The first time they send me a WS2076 but i was not...

I'm new into FTA. I just recently acquired a FTA system and was wondering some tidbits to install it and get as much channels as I can. My system is WS9036, OMEGASAT 5701, SG6000 with DMX521. The first time they send me a WS2076 but i was not compatible with the motor. I've trying to get...

Trying to post some issue I have but it does not let me at all.