Recent content by autiger62

  1. autiger62

    D* installer pulled a fast one?

    DANG! Does your wife complain much about your dish being inside your house? :rolleyes:
  2. autiger62

    How do I get D* to repair this damage?

    VERY good instructions, Mike.
  3. autiger62

    How do I get D* to repair this damage?

    That is, indeed, a pitiful excuse for a dish installation! The two stabilizer support arms are doing PRACTICALLY NOTHING as far as supporting the antenna! Not to mention the damage to the chimney! That's awful.
  4. autiger62

    signal integrity department

    Punctuation is grossly overrated. :)
  5. autiger62

    D* Vod

    Is VOD available ONLY in a streaming mode, or can you download a video to your DVR and watch it later? If you can D/L to DVR, does the selection expire? I suspect that the PPV's do but what about free stuff?
  6. autiger62

    DirecTV 11 Satellite - Tracking & Testing

    Get a grip, folks... A little refresher in "Rocket Science 101": D*11 is NOT in geosynchronous orbit, yet. It's in a geosynchronous TRANSFER orbit. It's in an elliptical orbit on the equator, with a perigee (low point) altitude of about 155 miles and an apogee (high point) altitude of about...
  7. autiger62

    distribution amplifiers

    I'm using the CE Labs 6004. Works well. 1x4 with 8db gain per output. CE LABS 6004 RF Drop Amplifier
  8. autiger62

    Frequency Attenuation

    Maybe you can find what you need here ... They have several notch filters and attenuators. RF Distribution, Amplifiers, Modulators, Combiners, Splitters, Video Distribution
  9. autiger62

    Azimuth, Elevation & Tilt settings for 32405?

    Elevation: 46.2 Azimuth: 136.3
  10. autiger62

    Can you run 2 Outputs from one antenna?

    Your problem MAY be WHERE your splitter is... If your splitter is between the CM7777 preamp and it's power supply, you'll need to use a splitter that will pass-through power to the preamp. If you're splitting AFTER the power supply, any ol' splitter will work...Just a thought.:) BTW, a...