Recent content by j_met

I eventually want to replace the coax splitter with an HDMI splitter and run one HDMI out of the receiver to a 1 X 4 HDMI splitter and run to each room. It is only my wife and I living here so it is ok if all the TVs are displaying the same show.

Not doubting your answer Broe but, if I hooked it up that way, how would it be different? Why is it working now? It is working now and it is not possible for me to put the power inserter between the dish and the splitter as I do not have an electrical outlet in that space. to give it power...

Chip - See updated drawing

I've had DirectTV for about a year at this house. I've recently had some issues with my receiver freezing up and stuttering with the audio. I actually think the hard drive is going out in it. I am going to do a hard reset and hard disk scan. Since I started to have these issues, I've done a...

Broke down and called customer service....Code that you need to use is 987....

How do I program a RC65X or RC66X to a mini client? I have tried holding Select & Mute until the light blinks twice, then entering 9 6 1 to clear, then entering 0 0 0 0 1 to link the remote but, it will not work.

How do I figure out if it's a power passing leg? ?

Shouldn't it go behind the tv instead of laying on the floor connected to a wall jack coming off the splitter? ?

I the installer came out last Friday and hooked everything up. It's still working but I noticed the power inverter is still plugged in to one of the wall jacks in a totally different room than the receiver. If I unplug it, everything quits working. What is it and why does it have to be...

I was thinking about that....the 2nd tv would be located in different room though...so I would have to buy like a 25 or 50 ft component....if I didn't want to do tat, my only other option is to get another client for the 3rd tv?

I just bought a new house. The people before me had cable. They had the main cable dropped in the a/c closet connected to a reg 4 way splitter. Each cable ran to a different room and connected to the cable wall box. My current setup is the HR-34 Genie with 1 mini client. What I want to do...

I can't seem to get the hr34 programmed to receive commands from the RC65RX remote

Can anyone confirm if I can use the ir remote with the receiver in the living room and a rf in the bedroom at the same time or do both remotes need to be rf to work at the same time on the same receiver?

That's exactly what I want and how I had my Dish Network hooked up...I just didn't know if there was another method with direcTV...current remotes ends in X so I need to buy 1 RF....thanks

I just got DirecTV Ive got the HR34 on the living room with a mini client in bedroom. I am getting tired of having to reset the HR34 everytime the mini client locks up on the grey screen. How do I hook both tvs to the hr34? (yes I know both tvs will display the same picture)