Recent content by Musher

All three dishes are 90cm. 2 are WSI and 1 Fortec. Waiting for that new Geosat one from Satellite AV.

Everything fine now just had to rescan now all channels back. I leave the Fortec on all the time. So something must have got messed up. Just have a three dish setup for 83w, 97w, 125w but now don't get PBS due to I only have a DVB-S unit. But thanks for the help.

Went to watch RTN today on 83w and all three channels are showing PBJ. RTN & Tuff TV gone? Anybody check it out and let me know if you are getting the same thing.

Leeche Lake, I have a Westinghouse TV too. They are a Sony on the inside and Westinghouse on the outside. Try the codes for the Sony. I have a VIP622 with a 5.3 remote. Musher

SATire good luck but I live near Milwaukee and I'll have some work for me this weekend cause my dish is on a ground mount with bricks holding it down and well it was on it side, not much damage but will look it over this weekend once the wind stop blowing. I'll have to re-set everything. Musher

I having the same problem with the pip one side looks fine and the other side looks like strechted verticaly even for HD. The other problem with L630 is that my OTA tuner seems weak now. Most of the time I was getting 100% before and now I get 60-70% even with big antenna's that still work...

What I remember about autumn is pulling out the training rig to start running the dogs to get ready for winter on the sled. The cool and cold mornings are the best times to run. The dogs see those harness they go wild and can't wait to go for a run either, try holding back 8 Alaskan Malamute's...

carlospr43, there was a couple of ther site's but they shut down on their own. Found this one listed on the freedbs dot org site and checked it out and now its the only place I found. Mine is used through the loop out of mine Fortec. Just helping out. Musher

goto simplefta dot com and look there, i found it there and they do have some third party firmware too but be carefull with that. Musher

Just re-scanned some of the sat's and found on 97.oW Safe TV Slate with the GloryStar logo on the bottom left. 11929 V 22000 and are asking for donation's and are try'in to get back on the air and satellite. Musher

Just helping out, cause I did the same thing when I first set up my dish and looked around at pictures and posting here and all the help I got from everybody!:) Musher

stanleyjohn, goto the wsi website an look up the dish WS9036 and scroll down till you see the pic's of the dish and click on the middle one and look at how the lnbf bracket is mounted to the arm. I'll get some pic's of my set up at first light tomorrow. Musher

Outbackjack, nice pics of your set up! But there is one thing wrong with it, the lnbf bracket is in the wrong spot. Look at picture #2, it is on top of the arm and it should be on the arm so the lnbf is not on the sweet spot of the dish. That means you might have to reset the dish a little...

I have an N-fusion HD and its a total joke and took it outand went to a Fortec. The DVB-S2 is only for Dish/Bev. It has NO Blind and dose not work well with a motor either. If you have fixed dish set up using switches it works fine other wise don't buy an N-fusion. Musher

Well I checked the setup and it was leaning forward so is was no longer plumb. So I put some shims under the temp mount that it is on and almost all SQ came back up even on 101 History is now at 60%. Will check back later in the day and tonight also. Its been so windy here in SE Wisconsin...