Recent content by SnockZilla

That's what I have been doing. It is a pain in the neck. Very time consuming. I wish there was a better faster way!

I am using the Pansat 2500. After scanning all my sats I realize that some channels come and go and I need to rescan to find new stuff. My question is what is the best way to do it to avoid double channels. What is the quickest way? Do I have to do a blind scan each time to find new channels...

Reference Position Question Should I reference every sat, only SBS6 or none of them?

Can anybody explain the settings for the Pansat 2500 using USALS. I looked in the manual for the Pansat and the directions are vague. I'm set for SBS6 my most south sat. I set the L & L. For me it is 75W 40N. I have no idea what the "Reference Position" is for or what it does. After I put...

Here is my problem. I am resetting my position from SBS6 to AMC6 being my most south sat. I moved the motor to 0 deg position. Reset the Pansat. Lined up AMC6. Went into USALS Sat pos is at 72 deg. I input my L & L at 75W and 40N. It When I highlight the move it wants to move the dish...

There is a reference position but when highlighted it only says "OK"

What sequence do I do first. Line up the sat then enter my L & L or L & L than line up the sat?

Got a Question I am lined up on AMC 6. I have the settings on my USALS set at 72 Degrees for the sat. I put in my L & L and it moves my dish 3.4 deg to the east loosing my signal. What am I doing wrong?

I am on my most south sat SBS 6 setup with my motor. In your opinion should I just keep it the way it is or would you try to line up AMC 6 as the most south sat?

Is there anything broadcasting 24/7 on Nahuel 1 and AMC 6 so that I can lock onto it? If so please post the freqs. Thanks

Yippie Yippie I got it!!! Scanned AMC-4 with no problems. This is so COOL!!! I want to thank PSB and ICEBERG for all their help. I would not have been able to do it without you guys. Thanks A Million!!!

I think I got it! It moved an I am scanning TP for ACM-4 I think. I'll let you know...hold on and keep your fingers crossed.....

I'm Confused!!! Ok, I put those setting in...but I must be doing something wrong somewhere in the setup. Somebody with a Pansat 2500 please respond on how to properly enter the settings using a motor. Thanks. Guess I'm on hold again till I get these settings figured out.....I'll be an...

I set the hardware limits... I set the hardware limits so that it will not swing more than 20 degrees to the east. I just don't know why the setting in the setup don't match. I set the dish/motor to SBS-6, my most south Sat with the position on the motor set at 0. Even when I go in under...

USALS Question OK, I'm ready to move the dish with the motor. A couple of questions before I hit the move button. 1. I am setting up to move to AMC-4 from SBS-6. I checked the sat in the Antenna Setup for AMC-4 with my Pansat 2500. It brings me to a screen where it has the Satellite...