If its a MDU make sure you have permission to mess with the headend.. I am assuming your "Line" is connected in it somewhere. I am assuming your apartments MDU setup is not MFH2? or they running a 3 sat or single 18" dish? If its a MFH2 setup you will not need the SWM setup as I understand.
You will need...
- Slimline 3 or 5 LNB 4 Port MS built in
- SWM8
- 4 lines from dish to SWM8
- STS-2, 4 or 8 D SWM splitter based on total boxes you have
- You should have taps or a wall plate with a splitter in it feeding the various outlets you have, else you will need to run the lines in your apartment. Those taps from the Headend to your apartment may be an issue unless your apartment is a homerun to the headend.
Receivers that support SWM are..
D12 (Standard)
R16,R22, R23 (Standard DVR)
H20, H21, H23 (HD)
HR20, HR21, HR23
When you swap thier Splitters/Taps out in your apartment you will put that single line "In From LNB" and then out from SWM 1 either to a Power Inserter (PI-21) then to teh STS2 Splitter then to the lines for each room. Or. SWM1 to a STS2 Splitter then put one rooms line on the powerpass out then hook the PI21 to that Wall outlet hen from the PI21 to the first box, and hook the 2nd line up to non powerpass. Make sure you do not power anything up until you are 110% positive everything is correct.
If you have a Box that is not SWM/FSM compatable you will have to run or use the 3 legacy outputs, 1 for NOn-DVR, 2 for DVR.