Ok, i switched cable from the lnb to different switches, 1st receiver came back with bad switch error window, did switch test, says i have fewer satellites than before. clicked cancel as not to save this. Seems to work ok.
2nd receiver still the same, missing most channels.
1 st receiver says switch is SW21
2 nd receiver says switch is SWAJ
Both switches are SW21 as stated on the switches themselves.
" Agonizing Fury - Under 148 does it display "Feed" instead of the correct type of LNB?"
I am not sure where to look for this information. If you are referring to the installation / point dish / signal screen, neither is displayed. Please let me know where to look for this information.
FYI. I am using a JVC system that was purchased at Sears many, many years ago. It was purchased for a lake house because Dish could not find any installers that would go out to this location. The house later burned to the ground, so i keep the dish system to use at our house in Dallas.
Changing the cables does not seem to have done anything, since right now everything is the same as it was. Except for error i receive about "not as many satellites as before" but everything still works the same.
I am attaching a diagram of the wiring setup, local channel dish was added later by dish, and it really has never worked the same since. Anything wrong with this setup?
Will try switching receivers asap. Let you know the outcome.
Thanks for everybody's help.
wiring Pic - [ame="http://www.flickr.com/photos/9968470@N07/3572955133/"]sat-wire on Flickr - Photo Sharing!@@AMEPARAM@@http://farm4.static.flickr.com/3653/3572955133_25a206cc23_m.jpg@@AMEPARAM@@3572955133@@AMEPARAM@@25a206cc23[/ame]