Social Feed

Chewie
Last reply · posted in Free To Air (FTA) Discussion
Hello Gents
I have one of these motors for about 2 years now, for about one year I had a 90cm dish on it, than I switch to a 1.2 m geosatpro dish.
I had to install the thicker arm to fit the new dish bracket and I noticed that the arm has a play on it, about 3 to 5 Deg. still works but I had to make adjustments to compensate, some sats the signal is not very strong, I just want to ask the forum if anybody has this issue or there is some adjustments i can make to get rid off the arm play.
please let me know.
thanks in advance
Chewie:rolleyes::rant:
5 Replies · 2936 views
turbosat
I have a 380 that I got last spring, don't think they've been out for 2 years, not sure. Is yours maybe the 280? No problems with my motor so far, they are supposed to have self-adjusting backlash now. Is the motor shaft loose, or is it the bigger tube somehow slipping on the motorshaft?
jibaro29
Take a good look at the motor shaft. Mine started to come apart. I used supper glue to seal it back up.
AcWxRadar
Although I have not experienced a problem such as this with the Power Tech motors (DG-280/380 series), I have found a problem with an SG2100 motor.

Where the tube attaches to the motor stem (shaft), there was some extra play here. I cut out a small piece of shim stock (about 5/1000ths) and fitted this on one side of the motor stem, then tightened the bolt really good.

The additional play here wasn't very noticeable when you inspected the motor itself, but when you attached a larger dish it became quite apparent.

This is one area that I would check, especially since you have changed the motor tube.

RADAR
C
i have a 380 and have noticed that if you apply pressure to the edge of the dish, the tube wants to split. im not really into the 2 piece tube design. the autobacklash adjustment of the 380 also seems too tight to let the motor operate realiably but i think i may need to rma my motor as others in canada seem to have the 380 working with a 1.2m. i also have a couple sg2100's and have also swapped one of the tubes with a 50mm from sadoun. on my 2100 the tube was actually too tight to fit and i had to file out the tube to get it to seat properly. the other issue i have with the 380 is that you cant tighten the tube bolt with the motor installed at my location. the motor mounting bracket makes it impossible. if the play is around the motor shaft then id think the only solution is to shim it as posted above. other wise the auto backlash adjustment should take care of it.

crackt out,.
Chewie
Hello Gents.
thanks for your suggestions, I will try to use a shim and see if this corrects the problem, I did had same issues with the SG2100 Motor and that was the reason I switch to the DG380 MOTOR.
I been looking at the SG9120 MOTOR, does anybody know the weight limit on this motor?
please let me know.
I will take my dish down and install the shim and report back.
Thanks.
Chewie.
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68664 Replies · 2680695 views
  • Like
Reactions: c-spand
sdfntx
Take It as It Comes - Steve Winwood
  • Like
Reactions: EatMyVolts
long_time_Dish
Take The Money and Run - Steve Miller Band
EatMyVolts
Run Joe -- Louis Jordan and his Tympany Five
  • Like
Reactions: Bobby
long_time_Dish
The Long Run - The Eagles
  • Like
Reactions: ClarkGable
ClarkGable
Long Train Runnin' - The Doobie Brothers
meStevo
Lifetime Supporter
Last reply · posted in TV Shows
Starting a thread klang !

After an amazing first 2 seasons and an 8 episode 3rd season still coming this year, season 4 has now been greenlit.

Keri Russell Wow GIF by NETFLIX
12 Replies · 1035 views
  • Like
Reactions: klang
K
Finished season 3 last night. Still one of my favorite shows.

Anyone else wonder if there might be something else going on with Callum? Seems to me he has too much access to Russian intelligence.
meStevo
One episode into season 4 that dropped today...

Jon Stewart Popcorn GIF
  • Like
Reactions: NYDutch
meStevo
Renewed for season 5.
  • Like
Reactions: NYDutch
K
Finished 4 last night. Great stuff.

They do like to end each season with a Bang!
KAB
KAB
Finished 4 last night. Great stuff.

They do like to end each season with a Bang!
Great ending, but it ran in circles most of the season.
M
Last reply · posted in DISH Network Support Forum
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
5 Replies · 222 views
Almighty1
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
I have a DISH Hopper 3 (Software H713) with Hopper Plus (Software P15403). I have not tried streaming services but I primarily watch TVB Jadeworld international package which is only available by streaming and when I have an issue, I usually have to go to a non-streaming satellite channel first before the streaming channels will work again. What software versions do you have and what is the error message if any are showing on your screen? or is that Dish downloading logo just stuck and never finishes?
  • Like
Reactions: charlesrshell
M
I have a DISH Hopper 3 (Software H713) with Hopper Plus (Software P15403). I have not tried streaming services but I primarily watch TVB Jadeworld international package which is only available by streaming and when I have an issue, I usually have to go to a non-streaming satellite channel first before the streaming channels will work again. What software versions do you have and what is the error message if any are showing on your screen? or is that Dish downloading logo just stuck and never finishes?
I'm on H713 on the Hopper and P15403 on the Hopper Plus. It shows internet connection issues and doesn't finish loading the various services. I see the "loading circle going around. Sometimes I get a message saying that the service is having trouble loading my content and to check the internet connection.
  • Like
Reactions: charlesrshell
Almighty1
I'm on H713 on the Hopper and P15403 on the Hopper Plus. It shows internet connection issues and doesn't finish loading the various services. I see the "loading circle going around. Sometimes I get a message saying that the service is having trouble loading my content and to check the internet connection.
Did it ever work correctly before? Hard to say what the problem is. Usually for streaming, it will show the Dish logo with lines sweeping down to show downloading, never seen the circle issue. Did you try a manual reboot, red button reset, power cord unplug/replug to see if it makes a difference.
  • Like
Reactions: charlesrshell
S
Did it ever work correctly before? Hard to say what the problem is. Usually for streaming, it will show the Dish logo with lines sweeping down to show downloading, never seen the circle issue. Did you try a manual reboot, red button reset, power cord unplug/replug to see if it makes a difference.
Might be worth just to ditch the hopper plus. No issues here on h713
  • Like
Reactions: charlesrshell
S
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
Buy a roku and dump the hopper plus you'll be better off. If you have a smart tv you don't need either one. No hopper plus here and no issues!!!
  • Like
Reactions: charlesrshell
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 16 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 1 views