Social Feed

D
Last reply · posted in C-BAND Satellite Discussion
I am using a DSR922 and SV360 Elite. I need to find out why the 922 has to be turned "on" to view vertical channels on my SV360. :confused:

These vertical channels are almost always on the flipped polarity satellites (vertical channels are even numbers); the 922 does not have to be "on" for the horizontal channels.

But, on W1 103W, the 922 has to be off for the channels to come in on the SV360.

I don't want to leave my 922 on all the time cause I can see faint horizontal lines across the television screen. I do not want to see those faint lines.

I am using only C-Band. The line comes into the house and is screwed into a High Frequency splitter with the power pass port going to the 922 and the other port to the SV360.

Any ideas why the 922 has to be on? Any ideas on what to change to be able to have the 922 in the off position? :)
5 Replies · 1382 views
Long Hair
Why not run the coax to the SV360, and than using the out or loop on the SV360 to the 922. Leaving out the High Frequency splitter?
Inno
Like what Long Hair said. The reason is that the way you have it hooked up only one of the receivers can control polarity.
Are you using a LNBF (voltage controlled polarity) or a LNB and feedhorn with a servo?
B.J.
I am using a DSR922 and SV360 Elite. I need to find out why the 922 has to be turned "on" to view vertical channels on my SV360. :confused:

These vertical channels are almost always on the flipped polarity satellites (vertical channels are even numbers); the 922 does not have to be "on" for the horizontal channels.

But, on W1 103W, the 922 has to be off for the channels to come in on the SV360.

I don't want to leave my 922 on all the time cause I can see faint horizontal lines across the television screen. I do not want to see those faint lines.

I am using only C-Band. The line comes into the house and is screwed into a High Frequency splitter with the power pass port going to the 922 and the other port to the SV360.

Any ideas why the 922 has to be on? Any ideas on what to change to be able to have the 922 in the off position? :)

I don't have a 922 so what I say is based on other receivers, but I'm curious whether you have a VCII module installed? On most C-band IRDs, if they have a VCII installed, when you turn it "OFF", it's not really off, just that the TV display is disabled, and while off, the receivers will often try to locate an active VCII channel (not many of those around anymore). I know my receivers would pause for a minute or so after being turned off, then would start cycling through the channels over and over looking. Not sure if it would ever stop or not.
With a 922, I don't know if they try to do something like that looking for DCII channels or what? But when you turn off a receiver like the 922, the LNB is still powered up, and unless it's doing some kind of searching like I describe, and actually changes polarity on it's own, most receivers will retain whatever polarity you've left it on, because the newer receivers generally send out polarity signals to the polarotor only for a few seconds, then stop, and the polarotor will usually retain that setting (assuming that you're using a polarotor rather than an lnbf).
But anyway, if you do have a VCII module installed, you might try pulling that out, since it obviously isn't of any use anymore anyway. It may stop trying to switch channels on you if you do that.
ParaclipseCKu
You hit hit the nail on the head! Just like with the VCII signal the 920/922 receivers when "powered off" will look for a DCII signal. If you "power off" on a non DCII channel and watch the front panel within a few minutes you will see the receiver indicate it has found a DCII signal when the DCII light comes on.
D
Thanks ya'll. I'm going to try what Long Hair said. Refreshing my memory from LongHair's reply, I seem to remember having done that set up along time ago when I was using the analog receiver as the dish positioner when I first bought my SV360. There were no polarity issues.

Then after having read, and read, etc. etc., I used information I either found on this forum or somewhere else and hooked up the receivers the way I have now. Polarity issues started happening with the flipped satellites causing the 922 having to be on.

Long Hair's answer makes sense to me. Now, since I got my Adjust All Satellite issue resolved, I can look forward to closing in on the flipped polarity issue.

B.J. -- That's true about the VCRS modules and the 922 being on even though the power is off. I remember you telling me a long, long time ago about removing the module. So, I did. Those issues we discussed were resolved. :)
My signature line says I removed all the modules. They are of no use, that's for darn sure!

I'm not trying to switch channels, only watch certain channels without the 922 having to be turned on.

I'll let ya'll know what happens.
M
Last reply · posted in DISH Network Support Forum
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
5 Replies · 193 views
Almighty1
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
I have a DISH Hopper 3 (Software H713) with Hopper Plus (Software P15403). I have not tried streaming services but I primarily watch TVB Jadeworld international package which is only available by streaming and when I have an issue, I usually have to go to a non-streaming satellite channel first before the streaming channels will work again. What software versions do you have and what is the error message if any are showing on your screen? or is that Dish downloading logo just stuck and never finishes?
  • Like
Reactions: charlesrshell
M
I have a DISH Hopper 3 (Software H713) with Hopper Plus (Software P15403). I have not tried streaming services but I primarily watch TVB Jadeworld international package which is only available by streaming and when I have an issue, I usually have to go to a non-streaming satellite channel first before the streaming channels will work again. What software versions do you have and what is the error message if any are showing on your screen? or is that Dish downloading logo just stuck and never finishes?
I'm on H713 on the Hopper and P15403 on the Hopper Plus. It shows internet connection issues and doesn't finish loading the various services. I see the "loading circle going around. Sometimes I get a message saying that the service is having trouble loading my content and to check the internet connection.
  • Like
Reactions: charlesrshell
Almighty1
I'm on H713 on the Hopper and P15403 on the Hopper Plus. It shows internet connection issues and doesn't finish loading the various services. I see the "loading circle going around. Sometimes I get a message saying that the service is having trouble loading my content and to check the internet connection.
Did it ever work correctly before? Hard to say what the problem is. Usually for streaming, it will show the Dish logo with lines sweeping down to show downloading, never seen the circle issue. Did you try a manual reboot, red button reset, power cord unplug/replug to see if it makes a difference.
  • Like
Reactions: charlesrshell
S
Did it ever work correctly before? Hard to say what the problem is. Usually for streaming, it will show the Dish logo with lines sweeping down to show downloading, never seen the circle issue. Did you try a manual reboot, red button reset, power cord unplug/replug to see if it makes a difference.
Might be worth just to ditch the hopper plus. No issues here on h713
S
Over the past few weeks, I have had problems connecting to streaming services (Netflix, HBO et al). When I go to the TV's native Channels, I have no problem. The Dish internet troubleshooter shows I have a good internet connection. I'm wondering whether it's an issue with my internet provider or a problem with the Dish software on the Hopper Plus. Anyone else seeing this?
Buy a roku and dump the hopper plus you'll be better off. If you have a smart tv you don't need either one. No hopper plus here and no issues!!!
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 6 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 1 views
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68663 Replies · 2680620 views
  • Like
Reactions: c-spand
long_time_Dish
Take It Easy - The Eagles
sdfntx
Take It as It Comes - Steve Winwood
  • Like
Reactions: EatMyVolts
long_time_Dish
Take The Money and Run - Steve Miller Band
  • Like
Reactions: RaiderPower
EatMyVolts
Run Joe -- Louis Jordan and his Tympany Five
  • Like
Reactions: Bobby
long_time_Dish
The Long Run - The Eagles
Gary Toma
Staff member Pub Member / Supporter Cutting Edge
Last reply · posted in DIRECTV Technical Resources Forum
The TPN Map Excel Presents all DIRECTV Channels:
​
National (50-States or wide/NAT+PR beams)
Local (Local-Into-Local or narrow/Spot beams)
​
Additional tabs provide:​
OTA the (Over-The-Air) Database
VOD (Video On_Demand) Records
Offline Records
Engr Records
Net Decoder a graphic presentation of all satellites and transponders
​
Domestic Satellites
@99W...... D11, D14
@101W.... D16
@103W.... D12, D15
@110W.... D5
@119W.... D8​

Understanding the TPN Map

Making Sense of the TPN Map Display Conventions
2171 Replies · 945987 views
D
Weekly Analysis for 10/28/2026:
K
ElectionHQ mixes testing with BBC News, CNBC, CNN, FBN, FNC, MSNOW, NewsMax and NewsNation

Some more reshuffles

Updating the TMSIDs for KSBI and KQCW to use the cable feeds with Thunder games instead of the OTA feeds

An additional commercial PPV channel is now on 9530
coolman302003
Monday 11/2 is a full slate for NBA League Pass as all 30 teams are playing and 14 out of 15 total games are on NBALP. Only one national TV game on Peacock/NBCSN (Thunder @ Cavs).

DirecTV is even having to use several MLB EI channels (from 745-748) and a NHL CI (770) channel to fit all of them in the guide close together. 5 games at 7:30 ET, 3 games at 8 ET, 2 games at 8:30 ET, 1 game at 9 ET, 3 games at 10 ET. Luckily NHL CI is light on Monday (3 games on CI).

DirecTV is providing both broadcast feeds for all League Pass games except Hornets, Magic, Bucks & Raptors that night. These are all teams that have local broadcasts via a OTA channel which is on spotbeams and have streaming deals (DTC) that are not exclusive DAZN teams which DirecTV just signed a deal with (à la Spurs, Grizzlies, Cavs, Pacers & T'Wolves). Its also very common that we don't get Raptors broadcast very often from TSN or Sportsnet Ontario on League Pass.

11/2/26 (MON) EASTERN7:00 PM7:30 PM8:00 PM8:30 PM9:00 PM10:00 PM
Peacock/NBCSNThunder @ Cavaliers
NBA League PassNonePistons (745) @ HornetsKings (755) @ Mavericks (756)Celtics (760) @ Rockets (761)Trail Blazers (764) @ Nuggets (765)Suns (769) @ Warriors (770)
Hawks (746) @ Pacers (747)Pelicans (757) @ Grizzlies (758)Jazz (762) @ Spurs (763)Raptors @ Clippers (766)
Nets (748) @ Knicks (751)Bucks @ T'Wolves (759)Heat (767) @ Lakers (768)
Wizards (752) @ Magic
Bulls (753) @ 76ers (754)
*No Hornets, Magic local broadcasts*No Bucks local broadcast*No Raptors local broadcast
  • Like
Reactions: Nate.O’Brien
K
Only the Knicks, Nets, Wizards, Bulls, Celtics, Rockets, Lakers, Warriors, Avalanche, Sharks and Bruins feeds will be using remaps of 24/7 RSNs that night. The rest will be relying on the part time feeds, including the Nuggets, Blackhawks and Kings who will be on their alt/overflow channels, and MSG Western NY will be live on channel 635-1 to carry Buffalo area ads during the Knicks game.

The NHL Network alternate will be live on channel 215-1 with Red Wings @ Panthers for those blacked out of Golden Knights @ Bruins on the main feed.

The Thunder @ Cavaliers game will be on one of Peacock Game Pass channels that night for commercial customers, they'll also have the back to back U-Conn Women's and Men's Basketball. One of the part time feeds will also be in use for WWE Raw via Joe Hand promotions.
dtv757
I could be wrong but the only RSN we dont have is NBC SN Philadelphia .
Neutron
Supporting Founder
Last reply · posted in The Chit Chat Club
Patrick Stewart died yesterday, October 28th at the age of 86. We lost yet another great actor. :(

9 Replies · 105 views
long_time_Dish
Rest in peace. Wow, so many good roles, but Jean Luc Picard will always be my favorite...
M
R.I.P.
mc6809e
Rest In Peace
sdfntx
R.I.P., Jean-Luc.