PrimeStar,
You are correct, the loop happens when people do not follow available instructions. I have had the receiver since early 2011, the very first samples and I have yet to boot loop it. I update to every new firmware.
What I did yesterday was add satellite and a channel. I then "unselect" the satellite since these was only 1 channel I could get from the sat. (in the satellite list removing the "heart" - btw this is AMC 116 which is directly south of me so I used it to line up on.) (
And I see no where in the small black user manual that says not to do this, nor delete a satellite for that matter.)
When I scrolled through that particular satellite on the channel menus (skipping through AMC 116, as it was not on the list), the unit rebooted.
O.K., so then I figured I could live with it by leaving AMC 116 "selected" and did so, even though all I get is a pattern. Everything was finally working fine, satellites lined up etc..., I got one good evening of performance after 2 months of screwing with it and I was finally happy.
So today I get up and the motor (SG 6100) won't go east beyond 1.9 degrees west (I have done nothing to the units since I used it last night) - another problem I have to work on now. I am no stranger to technology, and I understand everything has a learning curve. But this is incredibly frustrating.
ps. I got the motor problem resolved, but not exactly sure how I did it (reset the motor, unplugging receiver, etc..., ) or why it was not functioning.