I went back up a couple of your posts...you stated to change to standard, which I did (or was), while you were typing that. Later, I reread your post, and saw to set it (the first freq) to 10750, which I went back and did, and woo-hoo, it worked. Which leads me to this question...if I set it to standard, and let it start scanning at a lower number (I believe the default first freq is a four digit number), why would it matter if I left it there, or set the first frequency to 10750? If the first freq was a lower number, wouldn't it not eventually get to the 10750, and then continue on? What's the diff of setting the first freq to 10750 as opposed to a lower number?