Thanks guys! Your help are much appreciated.
This morning, I "fine tuned" my dish -- I took a small TV on my deck and while I was on the roof adjusting the dish, I "watched" the signal meter on TV, very frustrated in deed.
All channels on Tp5 show full-bar (97-99 on Kusat), so I used the "fox" channel to tune my dish, there is only one direction (elvation + azimuth) I can set the dish, so that fox can actually show up!

But after fox shows up, other channels show up good, except the audio on some channels on tp1, for these channels, the audio is like beep beep.
One funny thing is the pentagon channel, when I scan the tp, the signal level is 99, but I can not get the channel to show up, not that I like to watch Pentagon channel, it is just that when you know there is a channel, but you can not get it, it is really feeling bad...
The Tube turns out good, both video and audio, for ImageAsia, I get video but no audio. I get KBS, but no video no audio.
Since Kusat 2600 does not support blind scan, I can not get any feeds, even if I enter the numbers manually, I guess I have to scan them on a specific time?
Anyways, I now have about 30-40 channels, some in Spanish, the rests are in English, lots of shopping channels...
Thanks again guys!
Suibu