Hi,
This is my current setup,
Fortec Star Lifetime Ultra
Universal LNB
90cm dish
HH90 motor
My location is 44.2N and 70.1W (04253)
I guess I figured my due south satellite is AMC6.
Now, I've been using USALS to get the thing pointed at IA5 (I read on another forum that was a good idea to get started) and when it finally got there, I had no quality and 50% strength. So I went up, and moved it left and right, up and down, and absolutely no change in the quality. I would get occasional spikes in the strength (70-80%) But I could never hold it there.
I turned it toward AMC6 and when I got it so that the strength was near 60%, I would move the dish up and down, and would get a strength near 70%, but no change in quality.
Aggravated, I moved it back to IA5, and then switched over to DiSEqC 1.2 and nudged it over a little bit (to the east I think, but I'm not sure) SCORE! I had a strength of 70% and a quality of 50%. As soon as I went to scan for channels, it was gone. I tried nudging a little more, and I couldn't get it back.
Now I'm back where I started. I don't understand why it is so difficult to get this bloody thing aimed. My mounting arm is plumb, and I've gone through the P degrees and adding the 17 degrees for my area (thank you Sadoun), but I cannot get my quality (and most of the time) my signal strength to do anything.
I tried searching for some similar threads, and couldn't find any, I hope this one will be unique.
Thanks in advance!