Social Feed

Stuart Sweet
· posted in The Solid Signal Blog
Satellite TV has been a popular choice for boaters for decades. Unlike streaming, it works up to 50 miles off shore and the service is much more reasonably priced. I do believe that at some point we will see a better streaming solution for marine, but it's not there yet. For now, satellite is a much better choice

For those outside the "continental US"


If you're an Alaska or Hawaii resident, you probably know that satellite TV works a little different there. Instead of the pert little Slimline dishes we use in the mainland, the recommended dish is a 1.2 meter monstrosity that requires special mounting. The satellites that provide DIRECTV programming are roughly in line with Texas, and that's a long way away from Hawaii. So, you need the biggest possible antenna to pick up weak signals and deal with the interference that comes from aiming lower.

DISH customers in Hawaii are a little luckier because DISH's Western Arc fleet hangs out roughly in line with California and just west of there. No special dish is needed, but the great distance does mean careful aiming and the possibility of rain fade.

Satellite TV on the water


The same is true with satellite TV on the water. You'll need the biggest possible dish to pick up programming effectively. Intellian makes a 90cm dish for DIRECTV and dishes for all other services go up to 2.4 meters. In a case like this, it's "bigger is better" because it's hard enough to get satellite TV if you're in the Hawaiian Islands… add a moving vessel into the mix and it sure doesn't get any easier. It's best to choose equipment that will work for you the way it should.

When it comes to satellite TV for folks outside the continental US, Hawaii is a bit of a special case. In most cases you won't get satellite TV more than 100 miles away from the coast of the continental US. This is done to satisfy contracts and international laws. There's no much that mere mortals can do about it. However, with Hawaii, because it's part of the US, there's a little bit of the satellite signal that is allowed to show all the way from the mainland. In most cases, a ship large enough to have the right dish can get satellite service during an entire Hawaiian cruise.

Work with the experts


The good news is that you can get satellite TV in Hawaii. If you have a fairly small cabin cruiser you probably don't want a 10-foot-wide satellite dome on it. So, some smaller boats may be out of the running for satellite TV. You don't have to guess, though. Luckily for you there are marine satellite experts who specialize in this stuff. We are ready, willing, and able to walk you through the process. Our experts will help you choose the right equipment, and activate your service. We can even help you find a local installer. We can send one of our qualified technicians, or work with someone you already have.

It all starts with a call to Signal Connect at 888-233-7563. When you call us, you'll find trained experts who spend every day working with people like you. Our team is dedicated. We will get it right, the first time and every time. When we satisfy you, our job is done and done right.

Call us now! If it's after hours, fill out the form below. We'll get right back to you!


The post Can you use a satellite dish in the waters around Hawaii? appeared first on The Solid Signal Blog.

Continue reading...
0 Replies · 314 views
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68657 Replies · 2680145 views
  • Like
Reactions: c-spand
sdfntx
I Care About Detroit - Smokey Robinson & the Miracles
dishstaller
I Wanna Talk About Me - Toby Keith
Bobby
98.6 - Keith
harshness
I'm Easy - Keith Carridine
gms49ers
It's Easy - Boston
R
Last reply · posted in Computers and Gadgets
Lately my eight year old Dell laptop has been shutting off even when I have a full battery. I have had to keep it plugged up all the time to keep this from happening. Any idea what is causing this? I replaced the battery about three years ago.
2 Replies · 37 views
arlo
A recalibration might be needed. Even if it shows full, the individual cells may have become unbalaced. And the BMS chip in the battery reports false information to the pc.
Try this. Start it up in the bios/uefi and leave it there until the battery dies and it shuts off.
It might just keep running longer than in Windows. Or run for a short while and shut off.
If it's the first case. Probably just needs a balancing. If the latter, the pack might just be dead.
Not throwing stones but perhaps just a cheaply constructed battery with substandard cells. Could be.

Patience. Keep restarting it in bios/uefi until it won't fire up anymore.
Then plug the charger in and let it complete a full charge. And see what happens. If it's better.
Do the same thing one more time. Run it until it dies dead-dead. Then just let it charge, pc shut off.
When charged, it might be better. It might not be.

There are bench jigs that read the actual BMS and override it to let a tech manually monitor and charge the separate packs. They can also reset any "time bombs" in it that cause an otherwise good pack to show bad.
Maybe Santa will be good to me some year.

You might just need a new battery. Maybe the PC power management chip is going. A Dell common thing.
Leaving a laptop plugged in with a full battery is known to reduce the life. Asus for one recommends that you don't leave the charger plugged in all of the time even when shut down. And setting Windows to charge the battery to 85% instead of 100% increases life.
That's all I got.
dishstaller
That's all I got.
That was quite enough....I definitely learned something from your post. Thanks
TRG
TRG
Pub Member / Supporter
Last reply · posted in Computers and Gadgets
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
5 Replies · 274 views
b4pjoe
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
If you can't get into the router to reserve an IP address just don't use DHCP on the device that needs connected and assign it to a specific IP address in the network settings.
  • Like
Reactions: harshness
HipKat
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
They are not. Your best bet is to set up a third-party router, attached to the Starlink for your server, that you can get into, like a Linksys, etc
  • Like
Reactions: Foxbat
Foxbat
…it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
The Starlink V5 Install Kit I just got comes with the Mini Router. It is pretty limited in what it can do. For example, it can provide only one IP subnet at a time, no Guest Network, but it does support the pass-thru to a third-party Router. You can also split the Wi-Fi into separate 5 GHz & 2.4 GHz SSIDs to help some IoT devices that don't support 5 GHz bands to work.

The larger Starlink Router that still comes with the V4 Kit does support a Guest Network with separate IPv4 Subnet, but it's $120 from Starlink. And it still won't do DHCP Reservations.
harshness
If you can restrict the DHCP address space to assign addresses to one end of the subnet (i.e. x.x.x.50+), you can manually assign the IP address on pretty much any operating system. This is a default behavior on several popular routers. As the Router Mini only supports 235 devices, I expect that's already done.

Another option is to use a router that supports PoE to power the antenna. This article discusses that option (under PoE Power heading):

  • Like
Reactions: Foxbat
Foxbat
Now that I've had the v5 kit with the Mini Router, it's not as bad as I first thought. Yes, no DHCP reservations, but you can set up multiple SSIDs that have separate IPv4 subnets, and like the big brother, you can select from 192.168.x.0/24 or 10.x.0.0/16 (where "x" is 1-4).

You can also split a subnet and have different SSIDs for the 5 GHz and 2.4 GHz channels to handle some IoT devices. I haven't discovered what subnet the 2nd NIC on the router assigns, I'm guessing it's the first subnet.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
2 Replies · 44 views
dishstaller
Sorry for posting the wrong link. Just corrected it.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

2 Replies · 49 views
  • Sad
Reactions: Jimbo
Jimbo
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

They will have to look at the switching sections to determine WHY 2 trains were on the same track ... at the same time.
dishstaller
Thought this article might be of interest to some of you who might travel via train.