Social Feed

Stuart Sweet
Staff member HERE TO HELP YOU! Pub Member / Supporter Cutting Edge
· posted in The Solid Signal Blog
Satellite service has occasional rain fade. It would be great if it didn't. But, it's a fact that satellite signals sometimes have to travel through some very heavy clouds and that means that the satellite dishes themselves just can't pull in enough signal all the time.

But how reliable is satellite, and how much rain fade should you expect? Both DIRECTV and DISH have said that their service is over 99% reliable. Let's do the math. A year is 525,600 minutes (as fans of musical theater know), so 1% of that is 87.6 hours. That sounds like a lot of time spent down! Except, when you realize two things.

Taking a closer look at those numbers


First of all, that's on the high side. DIRECTV and DISH have to be very conservative with their numbers. Most people experience about four hours of rain fade total per year, even in areas where it rains a lot. You have to realize that any time you scale up a small amount of time per week into a whole year it's going to sound huge. If you lose signal for 10 minutes a day (and most people don't) that's almost nine hours a year. A whole work day! The point is you're turning average numbers into silly statistics.

Second of all, you have to compare this with cable TV. Cable's average relability is about 97%, which sounds pretty good too except that the amount of downtime is triple that of satellite. If you want to scale that up to yearly numbers so it sounds super scary, it means you could expect to spend about 270 hours without cable TV in a given year. That's about a week and a half. And that number is important, because unlike satellite, cable TV stays down until someone comes and fixes it. Satellite TV's rain fade fixes itself when the sun comes out, but you could be waiting days for a broken cable to be repaired.

How to deal with rain fade


I would like to say that no amount of rain fade is acceptable ever, but that's not a realistic point of view. The hope is that if and when rain fade happens, it's rare and fixes itself quickly. Also, rain fade is much less likely to happen at night when solar radiation isn't stirring up the weather and scattering satellite signals. So, if you're into that primetime programming, you'll have a better chance of avoiding rain fade during that time of day. It's not to say that there won't ever be any rain fade at night, only that statistically it's less common.

The real solution for rain fade is DIRECTV's Signal Saver technology. If you have a Genie DVR and it's connected to the internet, you already have Signal Saver. Signal Saver will automatically switch to a streaming version of your content if it's available. You'll get a popup like this one:

savermsg-1.gif


…and you'll be able to keep watching like nothing happened. You can stream for several hours this way and not even notice the difference. Since most rain fade disappears after a few minutes, this is a perfect solution.

If you're experiencing more than 5 minutes of rain fade per day on average, there are some things you can do. Properly aiming your dish with a professional quality meter can do a lot. Even if your dish is 1/32″ off aim, that translates out to being several MILES away from the center of the beam. You can get get double or triple the signal power by just tweaking the aim a tiny bit. In some cases, an amplifier can help but most modern satellite dishes won't work with line amplifiers.

Can you use a larger dish?


If there were a larger dish available then that could theoretically help, but really that's not an option for most folks. DIRECTV does have a dish for its Alaska and Hawaii customers. It's designed to work well in those cases, where the satellites are very close to the horizon. In the continental US, there's only about a 1% difference between DIRECTV's standard dish and its Alaska/Hawaii dish, which is twice the size and twice the weight. Generally you can make that up with aiming the dish properly.

If you're not sure about your next steps, call the experts! The folks at Solid Signal have tech support available to you, for free, during East Coast business hours. Call us at 888-233-7563, or fill out the form below if it's after hours. We'll get back to you quickly!


The post How much rain fade is acceptable? appeared first on The Solid Signal Blog.

Continue reading...
0 Replies · 352 views
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68657 Replies · 2680157 views
  • Like
Reactions: c-spand
sdfntx
I Care About Detroit - Smokey Robinson & the Miracles
dishstaller
I Wanna Talk About Me - Toby Keith
Bobby
98.6 - Keith
harshness
I'm Easy - Keith Carridine
gms49ers
It's Easy - Boston
R
Last reply · posted in Computers and Gadgets
Lately my eight year old Dell laptop has been shutting off even when I have a full battery. I have had to keep it plugged up all the time to keep this from happening. Any idea what is causing this? I replaced the battery about three years ago.
2 Replies · 37 views
arlo
A recalibration might be needed. Even if it shows full, the individual cells may have become unbalaced. And the BMS chip in the battery reports false information to the pc.
Try this. Start it up in the bios/uefi and leave it there until the battery dies and it shuts off.
It might just keep running longer than in Windows. Or run for a short while and shut off.
If it's the first case. Probably just needs a balancing. If the latter, the pack might just be dead.
Not throwing stones but perhaps just a cheaply constructed battery with substandard cells. Could be.

Patience. Keep restarting it in bios/uefi until it won't fire up anymore.
Then plug the charger in and let it complete a full charge. And see what happens. If it's better.
Do the same thing one more time. Run it until it dies dead-dead. Then just let it charge, pc shut off.
When charged, it might be better. It might not be.

There are bench jigs that read the actual BMS and override it to let a tech manually monitor and charge the separate packs. They can also reset any "time bombs" in it that cause an otherwise good pack to show bad.
Maybe Santa will be good to me some year.

You might just need a new battery. Maybe the PC power management chip is going. A Dell common thing.
Leaving a laptop plugged in with a full battery is known to reduce the life. Asus for one recommends that you don't leave the charger plugged in all of the time even when shut down. And setting Windows to charge the battery to 85% instead of 100% increases life.
That's all I got.
dishstaller
That's all I got.
That was quite enough....I definitely learned something from your post. Thanks
TRG
TRG
Pub Member / Supporter
Last reply · posted in Computers and Gadgets
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
5 Replies · 276 views
b4pjoe
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
If you can't get into the router to reserve an IP address just don't use DHCP on the device that needs connected and assign it to a specific IP address in the network settings.
  • Like
Reactions: harshness
HipKat
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
They are not. Your best bet is to set up a third-party router, attached to the Starlink for your server, that you can get into, like a Linksys, etc
  • Like
Reactions: Foxbat
Foxbat
…it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
The Starlink V5 Install Kit I just got comes with the Mini Router. It is pretty limited in what it can do. For example, it can provide only one IP subnet at a time, no Guest Network, but it does support the pass-thru to a third-party Router. You can also split the Wi-Fi into separate 5 GHz & 2.4 GHz SSIDs to help some IoT devices that don't support 5 GHz bands to work.

The larger Starlink Router that still comes with the V4 Kit does support a Guest Network with separate IPv4 Subnet, but it's $120 from Starlink. And it still won't do DHCP Reservations.
harshness
If you can restrict the DHCP address space to assign addresses to one end of the subnet (i.e. x.x.x.50+), you can manually assign the IP address on pretty much any operating system. This is a default behavior on several popular routers. As the Router Mini only supports 235 devices, I expect that's already done.

Another option is to use a router that supports PoE to power the antenna. This article discusses that option (under PoE Power heading):

  • Like
Reactions: Foxbat
Foxbat
Now that I've had the v5 kit with the Mini Router, it's not as bad as I first thought. Yes, no DHCP reservations, but you can set up multiple SSIDs that have separate IPv4 subnets, and like the big brother, you can select from 192.168.x.0/24 or 10.x.0.0/16 (where "x" is 1-4).

You can also split a subnet and have different SSIDs for the 5 GHz and 2.4 GHz channels to handle some IoT devices. I haven't discovered what subnet the 2nd NIC on the router assigns, I'm guessing it's the first subnet.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
2 Replies · 45 views
dishstaller
Sorry for posting the wrong link. Just corrected it.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

2 Replies · 49 views
  • Sad
Reactions: Jimbo
Jimbo
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

They will have to look at the switching sections to determine WHY 2 trains were on the same track ... at the same time.
dishstaller
Thought this article might be of interest to some of you who might travel via train.