Social Feed

Stuart Sweet
Staff member HERE TO HELP YOU! Pub Member / Supporter Cutting Edge
· posted in The Solid Signal Blog
If I had to guess, I'd say the last "desktop" PC I had left my office back in about 2013. For me, it's been laptops all the way since. It's not like I spend a lot of time out of the office, but the laptop form factor just makes sense today. The price isn't terribly different between laptops and desktops, since most desktops just use the same components anyway. Pretty much the only thing you're getting with a laptop is a keyboard and a display. Oh, yeah, and a battery. That's the point of this article. Laptops have batteries. Desktops don't. That wouldn't be too much of a problem, except it kind of is.

Laptop batteries aren't that good. Here's why.


First of all, let's separate out the two kinds of laptops out there. There are the slick thin ones like Microsoft's Surface Pro. Then there are the rest, which are thicker, bulkier, and heavier. Those thin ones tend to have decent batteries and they're designed with very power-efficient parts. They're also pricey. Other laptops tend to have parts that use a lot of power and batteries that aren't up to the task. This article is about those laptops.

First thing to know is that batteries are heavy. They're often the heaviest part of a device. They also take up a lot of space, making laptops thicker. So, laptop makers will want to put the smallest battery possible in a laptop. That's why a lot of laptops have two-hour battery life or less.

Second, your average laptop spends most of its life plugged in. This in itself isn't bad, but until recently most laptops were designed to charge to 100% when plugged in. Leaving a battery charged to 100% shortens its life a lot, unless you use batteries specifically designed for that purpose. (They're more expensive of course.) A laptop that spends most of its life charged to 100% can lose 3/4 of its battery life within two years.

It wouldn't be such a problem except you can't replace a laptop battery easily.


I have a 2016 laptop which I use as a backup. Its battery life at this point is about 35 minutes on a full charge. That's down from about three hours when new, and most of that capacity disappeared by 2018. I can get a replacement battery for about $50, but I haven't. According to YouTube, in order to replace the battery I have to remove a bunch of delicate components including the keyboard. I really doubt that would work.

In fact, I did try to replace a battery on an older laptop in much the same way. It kind of worked, I mean the new battery powered the thing. But it woudn't charge unless I went into the BIOS first and then rebooted, so clearly there was some compatibility issue. I gave up and just stopped charging it. It's AC-only now, that's how I think of it.

It's time to bring back replaceable batteries.


I get it. Making a battery replaceable means a thicker laptop. That battery needs to be encased in hard plastic, it needs a connector, all that stuff. But it's worth it. If you concede that most laptops stay on the desk most of the time, then do you really care if it's 1/4″ thicker? No you do not. What you care about is that when you do actually take the thing out of the office, you can use it. And I for one would love it if I could buy spare batteries and swap them in.

Yes, this is the same argument people make about cell phones. Those used to have replaceable batteries too. But there's a reason you want cell phones to be small and light. You do actually take them with you all the time. And, you can power a cell phone with a power bank about the size of your finger if you want. A power bank that delivers the 50-200 watts used by laptops is going to be a pretty big thing to haul around.

So just make the batteries replaceable. In fact, here's a better idea. Laptop makers can put in these tiny, light batteries that only power the computer for 20 minutes. That's fine, and if you want a bigger battery you just buy it. I mean, big deal. Why is this so hard to fathom?

The post OPINION: Time to put replaceable batteries back in laptops appeared first on The Solid Signal Blog.

Continue reading...
0 Replies · 281 views
  • Like
Reactions: FTA4PA
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68658 Replies · 2680179 views
  • Like
Reactions: c-spand
dishstaller
I Wanna Talk About Me - Toby Keith
  • Like
Reactions: RaiderPower
Bobby
98.6 - Keith
harshness
I'm Easy - Keith Carridine
  • Like
Reactions: RaiderPower
gms49ers
It's Easy - Boston
RaiderPower
Take It Easy On Me - Little River Band
  • Like
Reactions: dishstaller
R
Last reply · posted in Computers and Gadgets
Lately my eight year old Dell laptop has been shutting off even when I have a full battery. I have had to keep it plugged up all the time to keep this from happening. Any idea what is causing this? I replaced the battery about three years ago.
2 Replies · 43 views
arlo
A recalibration might be needed. Even if it shows full, the individual cells may have become unbalaced. And the BMS chip in the battery reports false information to the pc.
Try this. Start it up in the bios/uefi and leave it there until the battery dies and it shuts off.
It might just keep running longer than in Windows. Or run for a short while and shut off.
If it's the first case. Probably just needs a balancing. If the latter, the pack might just be dead.
Not throwing stones but perhaps just a cheaply constructed battery with substandard cells. Could be.

Patience. Keep restarting it in bios/uefi until it won't fire up anymore.
Then plug the charger in and let it complete a full charge. And see what happens. If it's better.
Do the same thing one more time. Run it until it dies dead-dead. Then just let it charge, pc shut off.
When charged, it might be better. It might not be.

There are bench jigs that read the actual BMS and override it to let a tech manually monitor and charge the separate packs. They can also reset any "time bombs" in it that cause an otherwise good pack to show bad.
Maybe Santa will be good to me some year.

You might just need a new battery. Maybe the PC power management chip is going. A Dell common thing.
Leaving a laptop plugged in with a full battery is known to reduce the life. Asus for one recommends that you don't leave the charger plugged in all of the time even when shut down. And setting Windows to charge the battery to 85% instead of 100% increases life.
That's all I got.
dishstaller
That's all I got.
That was quite enough....I definitely learned something from your post. Thanks
TRG
TRG
Pub Member / Supporter
Last reply · posted in Computers and Gadgets
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
5 Replies · 282 views
b4pjoe
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
If you can't get into the router to reserve an IP address just don't use DHCP on the device that needs connected and assign it to a specific IP address in the network settings.
  • Like
Reactions: harshness
HipKat
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
They are not. Your best bet is to set up a third-party router, attached to the Starlink for your server, that you can get into, like a Linksys, etc
  • Like
Reactions: Foxbat
Foxbat
…it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
The Starlink V5 Install Kit I just got comes with the Mini Router. It is pretty limited in what it can do. For example, it can provide only one IP subnet at a time, no Guest Network, but it does support the pass-thru to a third-party Router. You can also split the Wi-Fi into separate 5 GHz & 2.4 GHz SSIDs to help some IoT devices that don't support 5 GHz bands to work.

The larger Starlink Router that still comes with the V4 Kit does support a Guest Network with separate IPv4 Subnet, but it's $120 from Starlink. And it still won't do DHCP Reservations.
harshness
If you can restrict the DHCP address space to assign addresses to one end of the subnet (i.e. x.x.x.50+), you can manually assign the IP address on pretty much any operating system. This is a default behavior on several popular routers. As the Router Mini only supports 235 devices, I expect that's already done.

Another option is to use a router that supports PoE to power the antenna. This article discusses that option (under PoE Power heading):

  • Like
Reactions: Foxbat
Foxbat
Now that I've had the v5 kit with the Mini Router, it's not as bad as I first thought. Yes, no DHCP reservations, but you can set up multiple SSIDs that have separate IPv4 subnets, and like the big brother, you can select from 192.168.x.0/24 or 10.x.0.0/16 (where "x" is 1-4).

You can also split a subnet and have different SSIDs for the 5 GHz and 2.4 GHz channels to handle some IoT devices. I haven't discovered what subnet the 2nd NIC on the router assigns, I'm guessing it's the first subnet.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
2 Replies · 50 views
dishstaller
Sorry for posting the wrong link. Just corrected it.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

2 Replies · 53 views
  • Sad
Reactions: Jimbo
Jimbo
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

They will have to look at the switching sections to determine WHY 2 trains were on the same track ... at the same time.
dishstaller
Thought this article might be of interest to some of you who might travel via train.