As an alternative idea- A dish 1000 with one DPP Twin and one DP Dual run into to AUX port of the DPP Twin could be used. The antenna would be mounted on the same pole. Two RG-6 lines from the DPP Twin go into the SAT side of the diplexor. Two lines from the antenna go into the VHF/UHF side of the diplexor. Two lines go from there to internal home splitting location. Install the recievers there. Convert all the remotes to UHF instead of IR. Run your TV1 and TV2 lines staight from the back of the recievers. The SAT feed lines diplex back out in the same place. The SAT side of the diplexor will feed into a DP seperator. The VHF/UHF side of the diplexor will be run into a spitter. One line to the antenna in on the reciever. The other line goes to an "out" on a 2 way splitter. From the TV2 out on the reciever a line will go to the other side of that same splitter. The "in" on the splitter will be connected to the line of whatever room you want. (All this applies to both recievers.) SO... this way only one line needs to be run,there's no unsightly recievers in any room, and you'll get 4 rooms with independent progamming and the locals.
... but no component video or HDMI connections to TVs, right? So no HD TV? This is a nice idea (and one I had thought of, though not in this much detail), but I had discarded it because of that issue.
I am thinking that I will get someone (the installer?) to fish some more cables to my living room setup and make that the media center, with the ViP622 box, the HD TV, the DVD player, and a computer.
I think I'll need 4 RG-6/U cables and two Cat6 UTP cables.
One UTP for Ethernet, one for phone line.
The RG-6/U cables would be:
- 2 for sat input to ViP622
- 1 for OTA input to ViP622
- 1 for TV2 out to the rest of the house
I did see the post on combining basic cable and TV2-out on one RG6 cable. I might want to do that too.