I am moving to new home in such I need to setup 2 satellite dishes Ku band for 4 independent receivers where each one can tune H/V frequencies from both satellites. What is the minimal hardware setup for this scenario?
This would better be posted in the Free to Air (FTA) satellite discussion. This area is for Dish Network subscribers, but there is probably someone here who knows what you are talking about.
I am moving to new home in such I need to setup 2 satellite dishes Ku band for 4 independent receivers where each one can tune H/V frequencies from both satellites. What is the minimal hardware setup for this scenario?
If you mean two stationary (not motorized) dishes with four receivers then this post under the FTA FAQ section is what you need. The drawing at the end of post 7 shows the hookup required.
Introduction: Lots of basic switch questions come up every month. I'm no expert on the subject, but I've been paying close attention to the people who've been putting them to work. Some have come up with very complicated switching matrices from the simple building blocks. So, for a while, I've...
If you mean two stationary (not motorized) dishes with four receivers then this post under the FTA FAQ section is what you need. The drawing at the end of post 7 shows the hookup required.
Introduction: Lots of basic switch questions come up every month. I'm no expert on the subject, but I've been paying close attention to the people who've been putting them to work. Some have come up with very complicated switching matrices from the simple building blocks. So, for a while, I've...