New to Dish. Have 722k worked flawless (week) until last 3 days (added the OTA MT2 module over weekend).
If unit is off (still powered) for a few hours - when turning on - get Dish Starting screen - no lights, then slowly comes to life and says to hit "select" to view (this am). It has been happening last 3 days (twice on Mon) - stopped 5 min's into House OTA recording. Almost like it is in a deep sleep...
While running last nite - easily recorded 3 (1 OTA & 2 SAT) shows at same time. When powering up this am, again had to wait for it to start. It has also does this each day when wife turns on, & some occasions goes into acquiring sat screen 1 of 5.... then works fine while on.
Is it going to sleep, a setting I need to change, would the OTA module cause issues? Thanks for ideas.
If unit is off (still powered) for a few hours - when turning on - get Dish Starting screen - no lights, then slowly comes to life and says to hit "select" to view (this am). It has been happening last 3 days (twice on Mon) - stopped 5 min's into House OTA recording. Almost like it is in a deep sleep...
While running last nite - easily recorded 3 (1 OTA & 2 SAT) shows at same time. When powering up this am, again had to wait for it to start. It has also does this each day when wife turns on, & some occasions goes into acquiring sat screen 1 of 5.... then works fine while on.
Is it going to sleep, a setting I need to change, would the OTA module cause issues? Thanks for ideas.
