I had a 522 and upgraded my TV to a plasma, so I in turn upgraded to a 622.
I was hooked up on a Dish 500 with DPP running one coax lead to my 622 and the other coax to a second reciever. I installed a second dish (Winegard 78cm) with a Dish Pro LNB and I ran a coax from it to the unused input port on the Dish 500 LNB.
I could not get a signal from the new dish even after running the switch test. Next I covered the DPP with foil, had the install menu set for Dish 300. Still no signal.
What should I do next before calling out an installer?
I an located at 32.58N, 86.59W. I aimed the dish to elevation 43.4 Azimuth 139.0
I was hooked up on a Dish 500 with DPP running one coax lead to my 622 and the other coax to a second reciever. I installed a second dish (Winegard 78cm) with a Dish Pro LNB and I ran a coax from it to the unused input port on the Dish 500 LNB.
I could not get a signal from the new dish even after running the switch test. Next I covered the DPP with foil, had the install menu set for Dish 300. Still no signal.
What should I do next before calling out an installer?
I an located at 32.58N, 86.59W. I aimed the dish to elevation 43.4 Azimuth 139.0