I just got my Dish 721. I was previously using 510 and 311. I replaced 510 with 721. I have 2 dish 500s and supposed to be getting 61.5, 110 and 119 satellite signals. First I was just getting 110 and 119 when I ran the check switch on 721, but later I started getting all but when I click done, I get 2-3 error messages like error # 616, # 622, # 613. At the end, I get "Error # 020 with the message, "The smart card currently inserted is not valid for use with this receiver".
Tried several things like taking the card out and putting it back in, but it did not help. Aslo unplugged the dish cables from the back, run the check switch, but at the end I get the same smart card error message. Another thing is it re-starts like 5 times before it goes to "Point dish" screen. It doesn't even goto Menu. It gives three other error messages,# 616, # 622, # 613 before giving error # 020. Then there is no "OK" option, and you have to either shut down the system completely or take the card out to bring back to the "Point dish" screen.
Current SW version is L054HABD-N. Seems like the problem is the old software. Can I update the SW any other way than going to the menu?
I have tried unplug & plug back in. Also tried connecting directly (without the switch 34 but got the same error.
Single LNB is directed towards 61.5 and has one cable coming out of it. Dual LNB has 2 cables coming out and directed towards 110 and 119.
Any help will be appreciate.
Thank you,
Salman
Tried several things like taking the card out and putting it back in, but it did not help. Aslo unplugged the dish cables from the back, run the check switch, but at the end I get the same smart card error message. Another thing is it re-starts like 5 times before it goes to "Point dish" screen. It doesn't even goto Menu. It gives three other error messages,# 616, # 622, # 613 before giving error # 020. Then there is no "OK" option, and you have to either shut down the system completely or take the card out to bring back to the "Point dish" screen.
Current SW version is L054HABD-N. Seems like the problem is the old software. Can I update the SW any other way than going to the menu?
I have tried unplug & plug back in. Also tried connecting directly (without the switch 34 but got the same error.
Single LNB is directed towards 61.5 and has one cable coming out of it. Dual LNB has 2 cables coming out and directed towards 110 and 119.
Any help will be appreciate.
Thank you,
Salman