Does anyone know someone in or near Clinton, MS that could come by on thier own and point a 500+ dish on the side?
Dish point
- Thread starter wayne231
- Start date
- Latest activity Latest activity:
- Replies 1
- Views 4K
-
WELCOME TO THE NEW SERVER!
If you are seeing this you are on our new server WELCOME HOME!
While the new server is online Scott is still working on the backend including the cachine. But the site is usable while the work is being completes!
Thank you for your patience and again WELCOME HOME!
CLICK THE X IN THE TOP RIGHT CORNER OF THE BOX TO DISMISS THIS MESSAGE
I'm to far away to stop by but you should be able to do this yourself.
1) Make sure the mounting pole is plumb
2) Set the elevation on the dish to 44 degrees
3) Set the skew angle on the dish to 123 degrees
4) Slowly rotate the dish around the 218 degree azimuth angle until you get a good signal on the dish point screen and then lock it down. (When pointing the dish you're not pointing the dish face to the azimuth angle but rather you point it in a line parallel to the elevation angle brackets on the back of the dish.)
1) Make sure the mounting pole is plumb
2) Set the elevation on the dish to 44 degrees
3) Set the skew angle on the dish to 123 degrees
4) Slowly rotate the dish around the 218 degree azimuth angle until you get a good signal on the dish point screen and then lock it down. (When pointing the dish you're not pointing the dish face to the azimuth angle but rather you point it in a line parallel to the elevation angle brackets on the back of the dish.)
