I'm looking for info on where/how EPG data is stored on these receivers - it's probably basically the same for each unit, with a bit of differences here and there. I have a Fortec Classic, a Digiwave 7000, and a DSR-500, but would accept info/advice on this for any readily available model of FTA DVB receiver.
Basically, I'm hoping that somewhere along the line, someone has run into research as to where info is stored and how to load it onto a receiver. I don't mind a little serial port programming and poking around in memory if I have a bit of guidance. I'd love to build an EPG for a receiver using readily availble guide data from the internet, if I only knew where to start.
Surely the info is out there (heck people are doing WAY more ingenious [yet not so legal] things with these boxes than a stupid EPG!), I just need a little guidance to find the source.
Any advice would be appreciated.
Basically, I'm hoping that somewhere along the line, someone has run into research as to where info is stored and how to load it onto a receiver. I don't mind a little serial port programming and poking around in memory if I have a bit of guidance. I'd love to build an EPG for a receiver using readily availble guide data from the internet, if I only knew where to start.
Surely the info is out there (heck people are doing WAY more ingenious [yet not so legal] things with these boxes than a stupid EPG!), I just need a little guidance to find the source.
Any advice would be appreciated.